Electronics Forum | Thu Apr 20 07:17:11 EDT 2006 | meritajs
Hi All, We bought used ASYMTEK 402 but can not find software for this dispenser. Could somebody help us Thanks and best regards Peter
Electronics Forum | Wed Mar 31 06:08:45 EDT 2010 | miroyu
Hi everyone ! I started to program quad 4C for the first time and have some problems. First, board detection LED and proximity Led (on the front panel) are not lightning whatever I do! Second problem is I teach machine board size, nozzle locations
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
Electronics Forum | Thu Aug 13 19:51:47 EDT 2009 | prasadz
Jagadeesh Rajagopalan is the expert in MPM Screen printer Servicing and he suggest to do the calibration of Z axis with PCB thickness (1.3mm)
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Fri Sep 17 16:01:03 EDT 2021 | jamesatqkits
Hi Bukas, Do you have a CP45? I need some help: Ihave no board loaded, the machine is booted and homed. So to pick up a nozzle, I open the ANC window. Click on the nozzle I want, say 29 its a CN065 When I press pick, it asks, machine is not ho
Electronics Forum | Sat Sep 02 15:54:46 EDT 2023 | mekmat544
Hello, I would like to ask you for help. We have problem with our Selective Solder System SEHO PowerSelective. Problem is, that Z axis is decreasing. When we start soldering, height of Z axis is correct but after each solder cycle, there is decreasin
Electronics Forum | Wed Oct 24 09:25:23 EDT 2018 | filipblad
The solenoids seem to work properly and there are no problems when initiating the Z-axis
Electronics Forum | Tue Oct 23 11:18:23 EDT 2018 | tech1
It is probably one of the Z lock solenoids not working properly. These are located along the Z axis and as part of the initiation of the machine, the Z measure the travel. Check the upper and lower Z locks
A leader in automated fluid dispensing, jetting, and conformal coating. Products include stand-alone dispensing workstations and fully automated, in-line conveyorized systems with advanced process controls.
2747 Loker Ave. West
Carlsbad, CA USA
Phone: 760-431-1919
