Electronics Forum | Sat Apr 09 00:37:42 EDT 2016 | smtsparescn
Are you sure it can work even somebody do clone the software and copy to you, Normally it isn't like adding a patch to windows of a pc,
Electronics Forum | Fri Aug 06 05:04:45 EDT 2021 | oxygensmd
Hello Everyone, I am looking for manual for the following equipments: Asys MPS 50D (mag buffer), Asys TDM 03 (telescoping conveyor), Asys AES01 (1mag loader), Asys LSB 03 (stacker). I hope you can help.
Electronics Forum | Thu May 25 08:04:54 EDT 2000 | Mulitze
If you�re interested in new conveyers, contact ASYS via http://www.asys.de They offer a service in Europe and USA. Another worldwide company is JOT, contact via http://www.jot.fi (Homepage is in english) Best regards Bernhard
Electronics Forum | Wed Mar 31 06:05:04 EDT 2021 | micropak
Hello Everybody I am looking for the manuals of ASYS Un-Loader AMS01, in order to obtain the part number for the Toothed Belt of Pushing Rod assembly. Any help would be greatly appreciated.
Electronics Forum | Mon Apr 11 16:57:30 EDT 2016 | duoman
Kevin, have you contacted Tech Support?
Electronics Forum | Thu Apr 01 05:19:04 EDT 2021 | micropak
Thanks for the tip. I have the old belt and since it is too damaged (Steel wires showing up here and there)that measuring the length is probably not possible. I can however measure width and tooth pitch. I will give it a try. I have also requested A
Electronics Forum | Mon Apr 11 13:11:30 EDT 2016 | gbkellyk
Hi, I hope someone is able help me I have just purchased a used ASYS LSB03 bare board loader and when I have switched the unit on the display reads MODUL 02 OFF also the control panel is frozen and does not respond to any of the buttons when pressed.
Electronics Forum | Thu Nov 04 15:11:05 EDT 2021 | azdback
I have an ASYS conveyor that I repaced the motor conmtroller AMC 4-2 with a used one.( Old one lost all power) The used one is in German, and I have not been able to figure out how to change the lenguage to English. This particular conveyor has a mo
Electronics Forum | Tue Aug 14 15:44:04 EDT 2001 | davef
Check the fine SMTnet Archives for contacts at ASI and Conductive Circuits. They print materials on substrates to incorporate ECO, not sure about making the trace cuts, though.
Electronics Forum | Thu Apr 12 16:52:38 EDT 2018 | esoderberg
I also use Bluering formerly ASI/MET. We have been using Vectorguard stencils with them for a number of years.
.png)
