Electronics Forum | Sat Jan 29 16:35:33 EST 2000 | Robert Steltman
We have a Seho wave soldering machine and cannot seem to get rid of dross that is being generated within the solder pot, and is being pumped out in the wave. It is not the same kind of dross that forms on the surface of the solder pot(this is very m
Electronics Forum | Tue Feb 14 03:58:17 EST 2006 | Rob
Yes, it's fine - as Pete says you have to replace certain parts & either get the pot recoated or a new one. We ran a "Lead free" 6622C from Vitronics Soltec on Tin Lead, then it was cleaned up, recoated and loaded with a no-lead alloy with no proble
Electronics Forum | Mon Feb 13 13:26:21 EST 2006 | pjc
If you're asking about wave solder machine, yes you can run Sn/Pb in a "Pb Free" machine. The concern is that when its time to run Pb Free you're going to have to remove all the parts from the solder pot to remove all the Pn/Pb solder residue from po
Electronics Forum | Mon Jan 31 12:24:24 EST 2000 | Dave F
Robert: Several points: 1 Dross is a mixture of various things with no "fixed" composition: � The obvious things are metal oxides mixed with metal and this can vary in color with temperature and composition - remember some intermetallic oxides form
Electronics Forum | Fri Jan 28 12:30:57 EST 2005 | glenda
We are looking for a used or new wave machine must be able to do lead free solder. Does anyone have contact information in the Chicago, il area for used wave soldering machines? Thanks for any help we can get.
Electronics Forum | Tue Feb 17 09:33:43 EST 2015 | emeto
Hello, I have two of these for the last 3 years(MV-7xi). Buy the machine with the best camera they offer and with the telecentric lens - it gives great view and resolution. I had to replace the controller for conveyer open/close on both of them. I a
Electronics Forum | Wed Oct 13 15:45:04 EDT 2021 | dilogic
Does anybody have experience with ATF's selective soldering machines? Information on the web is scarce and their responses to my queries are either none or very limited. Any information is welcome...
Electronics Forum | Fri May 07 05:26:07 EDT 2010 | jlawson
Best have a chat to Rehm from their perspective. But galden does cost money. All depends on your production. Basically the more you run the machine, depending on design of machine, the more galden it uses... Open fixed mass galden type machines try
Electronics Forum | Wed Jul 27 18:41:48 EDT 2005 | crishan
Aj, You are correct, we use pallets to hold the motherboard, an X-Y table then transports the pallet through preheat section to the solder bath. I will check out your recommendations on the solder alloy. Supplier is not willing to share PPM data o
Electronics Forum | Wed Jul 27 03:50:51 EDT 2005 | aj
Crishan, I am not familiar with the machine you mentioned. Do you use selective solder pallets through a wave process or is the machine a selective soldering machine (ie. where the board is moved to the solder fountain) No matter what the process
