Electronics Forum | Mon Apr 23 10:22:02 EDT 2018 | robl
It also depends on how good your auditors are. We are very tight on calibration and maintenance across all sites but it's definitely the UK auditors that drive us to be better. They are the ones who match historical builds against tool calibratio
Electronics Forum | Tue Nov 15 16:31:04 EST 2011 | pcbrown
Can anyone tell me if the Metcal SP200 solder station meets the J-STD-001 Rev E requirement of holding a tip temp of +/-9F at rest? I am in a fight with an auditor over this. These irons do not require calibration but I need to know if they meet J-ST
Electronics Forum | Mon Feb 13 10:13:50 EST 2006 | slthomas
I have been through this before. At a med. device company they required every device that performed a measurement to be calibrated. O-scopes, calipers, 6-inch steel rules, etc. And thermocouples. While I can't see what difference it makes to the pr
Electronics Forum | Mon Nov 12 18:56:27 EST 2012 | cdeguchi
Hello, We are going through auditing and the auditor requests that we need to have some type of document indicate whether or nor this unit is required for annual calibration. Please kindly reply to this request. Thank you,
Electronics Forum | Thu Nov 08 12:10:53 EST 2012 | cdeguchi
Hello, We have 2 AOI Automatated Inspection Systems, Model YTV-BV, as we are going through auditing and the Auditor requests that we need to have documentation to indicate whether the units are required to calibrate annually or not. Please kindly r
Electronics Forum | Fri Jun 10 22:59:47 EDT 2022 | SMTA-64304451
I recently went through an AS9100D audit and discovered one of my equipment manufacturer's calibration certificates and stickers do not have a recal/expiration date. I realize ISO17025 stipulates the user is responsible for determining appropriate
Electronics Forum | Wed Mar 06 11:02:07 EST 2002 | slthomas
I worked for a medical instrument manufacturer a few years ago and we had to calibrate all measurement devices. That included everything from our vapor phase oven's thermocouples to 6 inch steel rulers. I don't see any logical justification if you'
Electronics Forum | Fri Feb 10 15:14:08 EST 2006 | Chunks
Establish a profile board. It should be representative of what you normally run on a daily basis, size and parts wise. Attach dedicated thermalcouples so they are permanent and will not move or come loose. High temp solder is best. Establish a pr
Electronics Forum | Fri Jan 13 10:39:53 EST 2006 | samir
Good one! I remember at my old company, the auditors, both internal and external would go immediately to the refrigerator where we kept our glue and solder paste and then they would spend most of their time there, because they were afraid of all of
Electronics Forum | Mon Feb 13 22:26:30 EST 2006 | KEN
You are correct. Regardless of what any auditor is asking what we're dealing with here is sound science and good Process Engineering. Standard methods for temp profiling are not absolute. If you are using a Temp simulator you are only verifying th
| 1 |
.png)