Electronics Forum | Mon Feb 21 20:20:01 EST 2011 | proy
I have a 1996 Camalot 1818, and somebody has broken the nozzle 'flat' tab on the auger body. Does anyone have a parts machine around? PR
Electronics Forum | Mon Feb 21 20:22:29 EST 2011 | proy
I have a 1996 Camalot 1818, and somebody has broken the nozzle 'flat' tab on the auger body. Does anyone have a parts machine around? PR
Electronics Forum | Thu Aug 30 09:49:32 EDT 2007 | blnorman
EDS @ 10kV maybe going too deep. I've talked to a surface science physicist that recommends Auger spectroscopy because it's more of a true "surface" examination tool.
Electronics Forum | Tue Dec 30 20:23:34 EST 2014 | jeff701
What does "maintain it really good" entail? For reference, this is our maintenance procedure for the FX-D: - At the end of an 8hr shift, the solder paste path is purged start-to-finish using Nordson's ValvePurge. The machine's then powered down and
Electronics Forum | Wed Dec 10 07:47:16 EST 2008 | benefon
If you find the correct type of adhesive/needle size then dispensing certainly is no problem. With a footed needle a very repeatable process too. Much more flexible than stencil printing and no need to mess around with stencil cleaning. But with auge
Electronics Forum | Fri Jun 04 16:30:10 EDT 2010 | jdm2008
I am running a cemelot 5000 and I am having trouble with the solder clogging up the needle. When the solder is removed it almost appears if it has reflowed. I am using a 22 guage needle, and the problem occurs with both type 3 and type 5 solder pas
Electronics Forum | Sat Jun 05 14:20:10 EDT 2010 | davef
It's a common problem. Try using a different needle diameter. Paste type||Suggested needle size II||21 or larger III||23 or larger IV||25 or larger V||27 or larger VI||30 or larger Additionally, improper clearance between the auger pump screw and t
Electronics Forum | Tue Jun 15 19:14:51 EDT 2010 | hegemon
You also need to consider the total metal load in your dispensable paste. You'll need a slightly higher flux content and less metal, say around 87% total metal, in a 4 or 5 mesh size. We had to have some special mixes made in order to do fine pitch
Electronics Forum | Fri Aug 07 09:31:21 EDT 2015 | esoderberg
We use Humiseal T300 latex mask for over 17 years. No smell. That said we have been dispensing several ways. One is a Asymtek 718 in-line machine using a 1 gallon pressure pot and their DV7000 valve. It is an auger valve that has been highly successf
Electronics Forum | Mon Feb 20 13:02:22 EST 2017 | ttheis
We tried both of these suggestions and the 3-1953 is less viscous than the 3-1944 so it will flow better on the board for our conformal coating application. What cleaning solvent is recommended for cleaning off the auger parts, etc.? I haven't been
A Manufacturer of High Quality, Precision, Automated Fluid Dispensing and Conformal Coating Systems, SMT Cover Tape Peel Tester and Lead Forming machines for through-hole component preparation.
611 Hollingsworth Street
Grand Junction, CO USA
Phone: (970) 245-0408
.gif)
