Electronics Forum | Tue Jun 05 05:52:54 EDT 2012 | bigvern
Hi, we are trying to locate a electrical schematic drawing for a Dehaart EL20 semi auto printer. If anyone can asist or point me in right direction it would be apprecaited. Looking for spare parts for same too or a spares printer. Cheers. steven
Electronics Forum | Mon Jun 18 22:08:45 EDT 2012 | bigvern
Hi, we are trying to locate some parts for a DEHAART semi auto printer, if anyone has any old spares machine, please advise. Have tried most of the phones numbers on this forum in regards to dehaart but all numbers are no use due to dehaart being fi
Electronics Forum | Thu Jun 16 08:52:38 EDT 2016 | emeto
I see your point and I know you can make this machines run, but it doesn't change the fact that when you need them most they will let you down. It is almost impossible to find spare parts for some of them, as they are no longer supported. If you have
Electronics Forum | Thu Jun 16 11:48:00 EDT 2016 | ttheis
I agree that if you end up with a machine that needs more repair than one in good condition is worth, then you have a boat anchor. That is what I am looking to avoid with this next purchase as I don't have much experience with auto printers. Your inf
Electronics Forum | Sun May 27 19:51:00 EDT 2012 | darby
Seeing as you say you only have a small amount of cash ... I'd also consider a semi-auto printer where you align a golden board, set up the two cameras by boxing or overlaying a pad etc, and then use the vernier adjustment to get each pcb to align wi
Electronics Forum | Wed Oct 13 21:22:52 EDT 2004 | saiwong
I urgently need the support of the SM Tech printer. Anyone knows who can support the spare parts & technical support. Please help.
Electronics Forum | Wed Sep 11 10:48:02 EDT 2013 | gregp
Hi Reese, The UIC machine is (was) good for higher volumes. Do you think these machines are less appropriate for smaller lot sizes and PCB's with just a few through hole parts? Also, are the UIC through hole machines still fully supported with ampl
Electronics Forum | Tue Apr 08 04:40:43 EDT 2008 | fnorradd
Hi, just wonder if anyone has any recommendations of where i can find spare parts for the adjustable PCB workboard holders ie, clamps, support arms and spring loaded supports etc. Basically looking for everything apart from main plate. Any details
Electronics Forum | Mon Dec 20 21:16:30 EST 2004 | adlsmt
DeHart went out of business some time ago. I do not know if someone bought the rights to sell spares but I do have a DeHart printer in storage that perhaps can be canabalized for the parts you need. I got it at an auction but it has some type of sens
Electronics Forum | Wed Sep 11 15:12:02 EDT 2013 | rway
"Do you think these machines are less appropriate for smaller lot sizes and PCB's with just a few through hole parts?" That depends. It will still save time if your lot sizes are small, as opposed to hand placement. I would not recommend buying an
.gif)
winsouce.jpg)
