Electronics Forum: automatic board support (Page 4 of 131)

Re: automatic stencil printers

Electronics Forum | Tue Jul 13 14:03:33 EDT 1999 | Earl Moon

| We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does

Used automatic stencil print recommendations

Electronics Forum | Sat Apr 12 04:07:21 EDT 2008 | sessioc

Good Point. Also, what about the type of solder paste your using - Are you getting a good release from the stencil? What do your boards look like after you print?

Used automatic stencil print recommendations

Electronics Forum | Fri Apr 04 18:08:26 EDT 2008 | comatose

We are a small OEM that runs a high mix/low volume environment. Typical runs are a couple or five hundred boards, one or two products per day. Currently, we are using a Quad DeHart SLC-20 semi-automatic stencil printer. (alignment is manual, printing

Automatic Screener support

Electronics Forum | Mon Feb 02 15:59:17 EST 2009 | kpm135

I am curious if anyone uses the Novatec vacunest support system with their Screener system. If so any opinions on how well it works would be appreciated. Also any thoughts on the Gridlock system would also be appreciated. Thanks

Board support issues

Electronics Forum | Thu Sep 20 17:02:10 EDT 2001 | jschake

So that the entire forum benefits, I recommend that you post your findings to the main forum discussion page, instead of replying to this thread. You may even find that others who have not participated in the OnBoard Forum have similar experiences t

Board support issues

Electronics Forum | Wed Sep 19 14:58:03 EDT 2001 | jschake

You provided excellent detail, and unfortunately I do not see anything out of the ordinary except the tooling issue. This brings us back to the original tooling related questions you had asked before. My apologies for questioning your process integ

Board support issues

Electronics Forum | Mon Sep 17 14:57:11 EDT 2001 | ert002

We are printing 0.012" apertures on a .012" Solder mask defined pad in a fine pitch BGA application. The board is 0.032" thick with very little room on the bottom to place support pins under these areas. Our first pilot proved extremely difficult to

Board support issues

Electronics Forum | Thu Sep 20 15:12:47 EDT 2001 | ert002

No problem on the feedback. Should I just reply to the same thread or email you directly at DEK? This is my first time using this site, but I imagine they have the capability to attach files, pictures, etc. I will probably be completing the study

Board support issues

Electronics Forum | Thu Sep 20 14:33:18 EDT 2001 | jschake

I'm not sure how soon you are planning to perform this experiment, but it certainly would be interesting to get a snapshot of any results you could feed back to give us all a sense of closure regarding this issue. Is this possible? My sympathy is w

Board support issues

Electronics Forum | Tue Sep 18 13:09:21 EDT 2001 | jschake

Hey, where's the 0201s? Just kidding. Off the top of my head, I do not recall seeing results of such a test. Nonetheless, I�ll consult with my peers and let you know if we come up with something that could assist you. That said, with a few more d


automatic board support searches for Companies, Equipment, Machines, Suppliers & Information

Gordon Brothers October 2-30, 2024 Auction

Best Reflow Oven
SMT feeders

High Precision Fluid Dispensers
SMT feeders

Wave Soldering 101 Training Course
design with ease with Win Source obselete parts and supplies

"回流焊炉"