Electronics Forum | Mon Mar 31 17:18:15 EDT 2008 | pstone
I am looking for idea�s for board support on Fuji CP642 thru CP742 and IP 3�s. We have tried using the Grid-lock system which worked on the IP�s but not on the CP�s. We have also tried using the Ready-set system and had the same results. We are gett
Electronics Forum | Tue Apr 01 12:52:34 EDT 2008 | pstone
Thanks for the insight. Most boards we are seeing problems with are 1.60mm thick (some less) and most of them are panelized. For your support pins what do you use to show operators where the pins should be setup? I have heard of using Plexiglas to m
Electronics Forum | Tue Apr 01 07:45:55 EDT 2008 | aj
Hi, We use the standard pin supports when necessary. Are your boards very thin i.e less than 1.6mm ? or maybe panelised ? Other things to check are Z0 placement height aswell as damaged nozzles,sticky nozzle/nozzle head , poor feeders along with t
Electronics Forum | Tue Apr 01 08:28:19 EDT 2008 | cyber_wolf
DANGER WILL ROBINSON ! DANGER ! If your operators are not real careful the OEM support pins can get under the table frame and bend it. I have seen this happen more times than I would like to discuss. CP's must have the following: 1. Proper part hei
Electronics Forum | Tue Apr 01 17:14:11 EDT 2008 | aj
Hi, We only have 2 lines , but I dont allow any of the Ops to set them up, I did once and winded up with 10 damaged nozzles and cracked caps on the boards ... If the problem is as big as you say it is , you should really spend some time setting it
Electronics Forum | Tue Apr 01 17:16:05 EDT 2008 | aj
actually , just had a thought. Do you have any products that you dont see this problem on ?
Electronics Forum | Tue Apr 01 14:09:09 EDT 2008 | cyber_wolf
I have always heard the glory of plexi glass templates but have never seen them successfully implemented. ECR changes make this system nearly impossible when you are trying to manage thousands of assemblies. We have removed the hand cranks from the
Electronics Forum | Wed Nov 06 12:52:28 EST 2002 | charlie
Check out one of the board suppport that are currently available: Grid-Lok, Formflex and others. These systems are available for many models of printers and P&P. They automatically set up to any board, first or second side, and provide excellent su
Electronics Forum | Sun Sep 12 08:20:04 EDT 1999 | se
| | | | hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the
Electronics Forum | Fri Sep 10 09:03:52 EDT 1999 | ScottM
| | hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the prec
