Electronics Forum | Sun Oct 18 00:04:14 EDT 1998 | Kallol Chakraborty
| Hi folks, | | I'm looking for PWB fab houses (for single sided, doublesided and multilayer boards) that you have worked with who are reasonable on price, excellent on support/response and great on quality. | | I'm at 800 323 9562 | | Mike Weekes
Electronics Forum | Wed Nov 18 10:45:22 EST 1998 | David Reese
Our company has been building high rel military products for over 15 years. Over that time we have reduced our bare board suppliers to two companies that specilize in 55110 QPL product. I am now faced with a requirement for 6000 4 layer boards to
Electronics Forum | Wed Nov 18 12:59:49 EST 1998 | Earl Moon
| Our company has been building high rel military products for over 15 years. Over that time we have reduced our bare board suppliers to two companies that specilize in 55110 QPL product. | | I am now faced with a requirement for 6000 4 layer boa
Electronics Forum | Mon Aug 27 15:50:05 EDT 2001 | seand
Hello Everyone, The MPM UP 3000 may be a good bet for your Screenprinting application and I am aware that there are a few in inventory at Speedline Technologies (MPM) that you should be able to get with a warranty for a good price. I know wide vers
Electronics Forum | Sat Sep 14 12:24:44 EDT 2002 | scottefiske
We need to remember here that as printer manufacturers were enhancing their product lines, miniaturization was quickly being developed in the background. In the last 2 years I was involved in developing and conducting a D.O.E./F.M.E.A in determining
Electronics Forum | Mon Apr 11 16:57:30 EDT 2016 | duoman
Kevin, have you contacted Tech Support?
Electronics Forum | Fri Jan 07 08:18:45 EST 2011 | mosborne1
We are a raw board manufacturer located in Charlotte, NC. we have been here since 1975. We can support all levels of volume. We can even ship double sided boards same day as we get the order. Check us out online - www.americancircuits.com
Electronics Forum | Fri Nov 18 14:08:44 EST 2011 | babe7362000
Is there anyone close to Ohio or in Ohio that is very familiar with the TRITON SMT IV Washer? Our tank is not staying hot to run boards thru. The temperature drops to 116. We checked all the heaters and they seem to be running fine. Any info is ap
Electronics Forum | Sat Aug 01 02:30:23 EDT 2015 | sarason
You could take a piece of aircraft grade aluminium, and machine you own. the advantage is you can set it up so you don't have to do any height compensation when you swap between a normal board, and your custom assembly sarason
Electronics Forum | Tue Aug 04 14:56:27 EDT 2015 | sarason
Adding to my previous message this could be solved fairly easily for the general case with a jig made from 3.2 - 4mm aluminium aircraft grade plate. you would machine the bottom side edges to give a 1.6 mm thickness, then machine the top side to leav
.png)
winsouce.jpg)