Electronics Forum | Sun Sep 22 02:32:33 EDT 2013 | alexeis
Hi, If your PCB is large, you waste a time. Any picture, you takes, will be with corner distortion. I suggest you to: 1. use AOI (manually or automatically) 2. try simulation of your PCB production before real SMT production process 3. use human FAI
Electronics Forum | Sun Oct 27 07:56:58 EST 2002 | wongmanchung
Does any expert here know the specification of board deflection when we mounting component by pick and place machine? That is when the nozzle place the chip on the pcb, the board will have some deflection. And are there any requirment that we need t
Electronics Forum | Sat Mar 20 07:36:20 EST 2004 | jdumont
I did not buy this machine from Contact, therefore they will not support it...unless you buy the 2nd user support package I think its called. I think a lot of people ask questions about Contact because there are so many used machines out there.
Electronics Forum | Thu Apr 30 14:05:16 EDT 2020 | davef
You're talking about lead forming equipment. GPD Global [ Mary Kohler, Sales & Marketing mkohler at gpd-global.com ] helps support SMTnet Other suppliers are: Manix, Ebso & Manncorp Regards, David Fish [davef] Technical Editor & Customer Advocate
Electronics Forum | Tue Jul 24 10:29:10 EDT 2007 | ed_faranda
Is there a reason why you want to wash the board before wave?!?!? What is your process flow? I run bottom side of my boards first, then top just to make it easier to setup (easier to put those support pins around those smaller components). But,
Electronics Forum | Mon Aug 13 10:00:18 EDT 2007 | ed_faranda
Might want to check to see if the weight of your part has increased. If it has increased, you may not have enough surface tension to hold the part on the board. I am assuming you already checked that the component isn't getting hit by something in
Electronics Forum | Wed Aug 10 14:56:03 EDT 2005 | pjc
"Too Hot" is any more heat than what is needed to reflow the solder. You should have the Auto-Profile software for the machine, this will accurately monitor and record temps. There is also port for the component itself to monitor package temp. There
Electronics Forum | Tue Jul 24 10:57:12 EDT 2007 | babe7362000
Is there a reason why you want to wash the board > before wave?!?!? > > What is your process > flow? > > I run bottom side of my boards first, > then top just to make it easier to setup (easier > to put those support pins around those smaller
Electronics Forum | Tue May 21 15:37:36 EDT 2013 | armelinda
I am looking for a service providing non contact PCB flatness measurement for open board SiP assembly. It was returned for failure analysis with complaint that assembly does not solder properly onto customer system board. Since there are remnants o
Electronics Forum | Tue Feb 16 13:57:50 EST 1999 | Ron Beasley
| | I have a recent design (1 component side only) that calls for 2 surface mounted antenna's (brass plated) to be mounted on a PCB. The problem arises when the PCB is 18x11.25 and has 15 to 20 PCB's in the pallet (IE weight, fixturing to hold the a