Electronics Forum | Mon Jun 19 08:49:40 EDT 2017 | westshoredesign
Just buy a separate machine to apply paste. You'll be able to run faster, (by doing more at the same time) and you can probably find an air-over-syringe system for less than $2000USD. At the end of the day, that's probably less than you'll spend in t
Electronics Forum | Fri Feb 26 08:30:10 EST 2010 | davef
Low cost prototyping * TWS Automation Quadra [www.tws-automation.com 39 0585 634758] * Versatronic RV4 [VSMT Solutions Ltd; 6 Dean Way, Aston Clinton, Aylesbury HP22 5GB, Buckinghamshire; 01296 630341 F01296 632144 http://www.vsmt.co.uk; David Clemen
Electronics Forum | Thu Jun 19 12:49:21 EDT 2003 | russ
Cal, I Agree Russ
Electronics Forum | Tue Jun 17 20:03:44 EDT 2003 | samaniegocesar
Hello Jipp. Before I recomend something, can you send to me a picture of the PCB (Bare board) and one picture with the PCB with components, I could help you. samaniegocesar@smtnet.com, samaniegocesar@hotmail.com Regards...
Electronics Forum | Tue Jun 17 15:51:42 EDT 2003 | equipres
Jipp, we sell used equipment for PCBA. I could most likely steer you in the right direction if I knew a little bit more about your product. Feel free to e-mail sales@equipmentresource.com or give me a call at 303-287-9333. Ken Fry Equipment Resource
Electronics Forum | Wed Jun 18 16:06:32 EDT 2003 | russ
Not that it is important, but Manncorp is not an O.E.M. They buy equipment and put there name on it. Sometimes this can lead to service issues (sometimes they need to call the OEM to resolve issues which can lead to delays). I am not saying that th
Electronics Forum | Wed Jun 18 06:41:34 EDT 2003 | emeto
Hi Jipp, If we are talking about 200-500 boards per month the main question is"Is it reasonable to go for semi-automatic production?". You will nead at least 1.Manual stencil printer 2.P&P machine 3.Infrared dryer or reflow oven Most expensive par
Electronics Forum | Wed Jun 18 16:03:03 EDT 2003 | mkehoe
Orrrrr, just buy a small reflow oven, 5K to 7K, and eliminate the paste printing by using solid solder deposition. No shorts, no opens, no cleaning, and no voids. www.sipad.com If you decide to print your own paste later you can invest the extra 30
Electronics Forum | Thu Jun 19 10:02:48 EDT 2003 | caldon
Russ- You are correct!! Manncorp is not an OEM, but they do have exclusive North American rights to certain Product lines. OEP is better named Original Equipment Provider. I do disagree with you though on the service issue. Siemens Has a problem th
Electronics Forum | Tue Jun 17 13:12:57 EDT 2003 | Jipp
We designed small PCBs (typically 2"x5")for our some of our products for quite some time now. We did not use PCB extensively and just hand-produced everything but... We now use them more and more and they got more sophisticated. we're heading for 20