Electronics Forum | Tue May 26 23:42:20 EDT 2020 | smiran082
Hello, I am having trouble the QSV-1 PNP machine. On boot it had trouble connecting to the RT computer as it was hung on a message saying something along the lines of, "Establishing connection to RT computer". After several restarts we still could
Electronics Forum | Mon Feb 18 09:49:43 EST 2019 | bobpan
This is going from my memory from a long time ago...but in the scp.ini file....there could be digital light control and/or a matrix tray handler setting. I would turn them off if they are on. I believe this has something to do with a system setting.
Electronics Forum | Fri Jan 19 07:21:07 EST 2007 | meritajs
Thank all for your advices. But we had sistem error,which was connected,how we could undestand with failure main PC controller boards.We had swoped winchester memory block and Zevatech operation was restored Best regards Peter
Electronics Forum | Wed Feb 17 12:19:41 EST 2010 | cyber_wolf
Remove the HIMV-134 card. Unscrew the piggy back memory card and re-seat it. See if that helps.
Electronics Forum | Sat Feb 02 04:48:30 EST 2019 | dfl
yes it's moving at the wrong pitch, about 3 components a time. Is the programming you talking about at the microcontroller AT85C55 or that serial memory 24C04? Or there is some procedure on the Quad to adjust this?
Electronics Forum | Wed Feb 23 13:50:55 EST 2005 | c.b
I am currently using a quad 1000, and up to now it has been a good reliable machine upto yesterday. I now have an error message that reads "driver error, emergency stop" the machine then freezea and will not run. Could some one please tell me if t
Electronics Forum | Sun Dec 02 00:17:35 EST 2007 | jmelson
I finally figured it out - in my manual it shows as a "63:Overflow" and says it has run out of memory for management information. I finally realized they were talking about the MIS statistical data of feeders, heads and mounting programs. I cleared
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Mon Dec 03 14:53:54 EST 2007 | jmelson
Well, it mostly does. The explanation and how-to-fix fields of the error chart do contain some howlingly bad translations. But, the how to fix field said the management info needed to be cleared. Once I understood they meant the MIS statistical dat
winsouce.jpg)