Electronics Forum | Fri Sep 25 14:58:33 EDT 2009 | gantry228
It is apparently a Q-series machine, if the adjustment for pitch and roll doesn't work. You may have to loosen or remove the quadalign then check the "wavey" washers to ensure they are there and opposing each other (these provide like a spring effect
Electronics Forum | Thu Sep 24 17:00:03 EDT 2009 | dogsbody
would any body be able to supply me with infomation on how to adjust a quadalign unit,as a unit on my line will not pick up 0603 resistors,but will pick up thicker 0603 caps. My manuals offer no help.I have run the aligner calibration with the cone t
Electronics Forum | Tue Jan 24 08:01:32 EST 2012 | wolverine
When using the rectangular plate given with the machine that is used with calibrating the movable camera, does the longer side of the plate get fed into the machine ( rails set to 80mm ) or the shorter side ( rails set to 74mm ) Thanks Dave
Electronics Forum | Mon Jan 03 12:39:46 EST 2022 | vasu278
Is it necessary to set adjustment mode 2 during calibration but iam unable to change the setting after changing unable to save and the screen appears as shown in image below
Electronics Forum | Tue Jun 29 13:42:20 EDT 2004 | sigmaprint
You will need to set the contact and squeegee zero calibration every time you set up a new product, we do this because the thickness of the substrate (pcb) can change between product and this will effect these calibration settings. The machine does n
Electronics Forum | Mon Jun 15 05:09:47 EDT 2020 | compit
This is not calibrated - it is set with a screw. Send a model or photo.
Electronics Forum | Sat Apr 03 14:17:26 EDT 2010 | dman97
Thanks again for your help. I never would have guessed to check the SPC data settings because we never use it. Thanks so much!
Electronics Forum | Thu Dec 11 00:00:22 EST 2003 | david2002
Does anybody have the measurements for the dimensions of the CyberSentry fiducial calibration board. This is a board used to set the machine up if paramter files are lost. Our board has gone missing and cyber optics has a long lead time. We can easil
Electronics Forum | Mon Sep 09 10:15:29 EDT 2019 | oxygensmd
Hello Everybody, I have a Siplace S20 machine which make X axis counting error. I replaced the sensor, scale and all the parts are good. It seems to be measuring error because the machine do measing error if the X axe move to much. Do somebody have
Electronics Forum | Wed Mar 06 20:46:31 EST 2024 | erikfriesen
Does anyone else calibrate Samsung CP feeders? I've done a handful here on my machine, I wonder what the proper way to do this is. Set the rear stop first, then the front notch point? They seem to need to be together, but its a bit cumbersome to g
