Electronics Forum | Mon Feb 09 12:27:41 EST 2009 | markhoch
I too am interested if anyone has any assistance that they can provide. A few years ago I took a table top, manual pick and place system and had a "table" machined that would allow me to bolt it onto one of our two meter, Inspection Station, conveyor
Electronics Forum | Wed Jun 03 16:26:37 EDT 2009 | wisch123
The most innovative new technology today is ccoming out of Fuji. They don't really advertise, so if you haven't gone to a show lately you might not have seen it. The machine is call the XPF-W and it sets the new standard for quality, accuracy, reliab
Electronics Forum | Fri Jul 29 11:31:44 EDT 2022 | jojoled
Hi Guys, I have Juki PnP machine with 2 heads, and for some reason, whatever I do, I can not make the machine to use 2independent feeders for parallel picking up single component reference by both heads from 2 feeders. Example , imagine you have a
Electronics Forum | Thu May 30 17:17:42 EDT 2013 | andrew88
These systems normally use pneumatic suction cups, attached to a plotter-like device to allow the nozzle head to be accurately manipulated in three dimensions.
Electronics Forum | Wed Jun 17 18:38:21 EDT 2020 | dilogic
Blue rectangle on the screen is actual search area. Green cross points excatly to the component centroid how vision system determined it - so, your component was picked slightly off center but still within the range. Now, the reason for offset can be
Electronics Forum | Thu Dec 13 10:39:38 EST 2007 | lloyd
Hi Mefunak, I'd say that the vacuum holding circuit is at fault. If the component is picked OK from the feeder ('vacuum check after pickup' is switched on) then the component is being dropped from the head as the gantry moves to the placement positi
Electronics Forum | Thu Jul 07 19:39:18 EDT 2005 | darby
This is a very difficult question to answer as it will depend greatly on your component mix. I will presume that the CSM 84VZ is of the following configuration: 2 x RDC Synchro Heads. Heads 1 & 2. These are mechanically centering heads with a chucki
Electronics Forum | Thu Apr 30 16:13:38 EDT 1998 | Chrys
| | | | | Hello - | | | I am interested in obtaining information on the possibility of integrating a Vision Inspection System with an SMT line. I am aware of systems which may be used to gather placement data and such, but are there any systems whic
Electronics Forum | Thu Apr 30 15:04:37 EDT 1998 | Steve Gregory
| Hello - | I am interested in obtaining information on the possibility of integrating a Vision Inspection System with an SMT line. I am aware of systems which may be used to gather placement data and such, but are there any systems which are able to
Electronics Forum | Thu Apr 30 15:39:43 EDT 1998 | Earl Moon
| | | Hello - | | I am interested in obtaining information on the possibility of integrating a Vision Inspection System with an SMT line. I am aware of systems which may be used to gather placement data and such, but are there any systems which are
