Electronics Forum | Thu Dec 10 09:09:31 EST 1998 | Earl Moon
| Hi everybody? | I heard that typical FR-4 would not acceptable for BGA application. | What is the main reason? | (thermal property? or CTE?) | Sombody please answer me the requirement of PCB substrate for PCB application. | Thanks. | | Youngho Son
Electronics Forum | Sun Feb 10 15:14:25 EST 2013 | marcelorotofrance
After an in depth examination, I found that the problem was not a defective connector as I thought in the first place. Actually is a broken through-hole on the Quad Align sensor. I requested a spare part to PPM. Mr. Bobpan, thank you again.
Electronics Forum | Mon Aug 28 18:57:41 EDT 2000 | Earl Moon
Steve, This is a good, well repeated, not identified by IPC yet issue. I, and some others in industry, for years have proven and recommended smaller pads for various devices. I, and some others in industry, use 0402 pads for 0603 device types. IPC o
Electronics Forum | Sat Nov 14 08:00:34 EST 1998 | Earl Moon
| Also the preheating of the board is done to help evaporate any water/alcohol that is in the flux - water is a big problem in No-clean processes. From our experience, a temp range around 200f - no more than 220f is ideal for the bigger boards, but t
Electronics Forum | Wed Jun 02 09:50:00 EDT 1999 | Earl Moon
| Hello all | I have a question concerning whether or not there is any special requirements to follow for assembly of a Polyimide PCB card. The customer has the following information on there documentation but since we have never built anything with
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Wed Jun 10 18:40:00 EDT 1998 | Earl Moon
| I am looking for the Industry standards on vias. Are they required to be plated with solder or is copper plating enough? What about reliabilty with either one? Also, if tenting the via is required should it be copper plated or solder plated over
Electronics Forum | Mon Feb 15 15:33:47 EST 1999 | Earl Moon
| Any info on the pros and cons of FR4 or Polyamide ref the use of soldering PGAs would be helpful. ie. temp co-efficient diffs, baking, wave soldering, Convection reflow etc | I'm sure you know all the basic differences as Tg, X, Y, and Z expansi
Electronics Forum | Fri Mar 13 15:09:20 EDT 2015 | marcelorotofrance
Hello everybody Lately our machine has been working pretty well, but it can’t last too long. Now, during this week’s production cycle, it began to increase the component’s reject rate to alarming levels (obviously the operators reported me when the m
Electronics Forum | Thu Jun 13 14:41:40 EDT 2024 | tommy_magyar
Hi David, In one of my previous jobs I worked as an AOI/AXI process engineer and we had a set target of 75% FPY. This means that 75% of the boards at IPC Class 3 standards would not have a single false call. This also means you would need to set y
