Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler
Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu
Electronics Forum | Fri Dec 16 19:19:59 EST 2022 | gabriel1blue
Hi guys. I have an old panasert pick and place machine that I'm trying to get working, but now we encounter an error after we power up the machine but when we try to complete origin process. Everything completes the process except for DST-PSOI and af
Electronics Forum | Tue Jul 09 15:20:19 EDT 2002 | pjc
When you look at the capabilities of Combo machines they tend to sacrifice performance when compared to separate X-ray and AOI machines, meaning they don't do either the X-ray or AOI operations as well as a machine that was designed to do only one. A
Electronics Forum | Thu Oct 25 19:53:42 EDT 2012 | sonavc
Thank It worked without the user name and password.When I try to zero axis I have other error unable write to global memory 5008. My machine, when turn it on i don't see the power to the Digiplan 8 axis modular and no bright on 24VAC on at servo co
Electronics Forum | Fri Oct 28 02:18:03 EDT 2022 | kamedatec
I bought a YV100XG machine with AutoTC (Automatic Tray Feeder), Everything is working except AutoTC, when I active this function, pops up the error that the Servo Motor LZ1 was not found. I changed the control card of the servo motor, checked the wir
Electronics Forum | Thu Nov 10 00:38:54 EST 2011 | tpappano
Hi Jeff, no problem, I'll just pop them out and make copies. I'm betting the upgrade will take care of these silly problems. The machine with the "newer" firmware just goes and goes without any issues other than replacing that R-axis servo a while
Electronics Forum | Wed Nov 09 23:02:34 EST 2011 | jeffr
Tom, I cannot find the software to operate my Sunshine EPROM burner right now. It is safe for you to read out the files on each of the ROMs using your burner. It is just a plug in, plug out operation to get the machine going again. The machine will s
