Electronics Forum | Tue Apr 28 09:27:53 EDT 2020 | assuredtech
On power up, push and hold the F1 key during the complete boot up, this will force the machine to boot into it's I/O menu, this allows you to verify the conditions of all of the sensors and confirm if it is waiting on an input from a sensor. Most com
Electronics Forum | Wed Oct 24 07:33:44 EDT 2018 | tech1
when the machine initiates the last move it does is in the Z axis. If memory serves me, during the last Z move it drives down and measures the stroke, if the lower solenoid is not fully retracted the axis measures the wrong travel limits. Hopefully t
Electronics Forum | Mon Jul 18 21:36:18 EDT 2022 | ttheis
We have two GSM machines (4-spindle, single beam) and had a camera fail on one machine. We decided to clean and calibrate the cameras on both machines. One machine we had no problems and all is working properly. The other machine will not pick up the
Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery
Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin
Electronics Forum | Sun May 21 23:29:38 EDT 2017 | zsoden
Hi all, We run an old Seho 1135C wave solder with a 63/37 pot at 250°C. It has been running well for a couple of years but we have noticed lately that all of the larger pads (terminal blocks, transformers, etc.) require additional solder to be appli
Electronics Forum | Mon May 01 08:45:24 EDT 2017 | ilavu
Tom, Its not the scale but the switch itself because while zeroing, if you activate front limit switch for Y axis, Beam should travel back to look for home pulse. It looks like switch signal does not reach to the system.It is really hard to trace the
Electronics Forum | Thu Jun 25 14:41:07 EDT 1998 | Earl Moon
| Alright gentlemen and ladies of the forum, I again seek knowlage on what is probably a well known fact. I have spent a good part of the morning with various IPC standards and weighty tomes such as the Electronic Packaging and Interconnection Handb
Electronics Forum | Sun Mar 07 08:19:24 EST 1999 | Earl Moon
| | | | | | | | I'm having a fun time between BGA rework/repair using an SRT 1000 and SPC efforts (much easier) using DEK stencil printing processes and BTU reflow with 6 Fuji lines in between. | | | | | | | | Concerning the BGA stuff, I'm getting
Electronics Forum | Sat Mar 06 20:46:21 EST 1999 | Dean
| | | | | | I'm having a fun time between BGA rework/repair using an SRT 1000 and SPC efforts (much easier) using DEK stencil printing processes and BTU reflow with 6 Fuji lines in between. | | | | | | Concerning the BGA stuff, I'm getting about 60
Electronics Forum | Fri Jun 26 11:27:12 EDT 1998 | Earl Moon
| | Alright gentlemen and ladies of the forum, I again seek knowlage on what is probably a well known fact. I have spent a good part of the morning with various IPC standards and weighty tomes such as the Electronic Packaging and Interconnection Han
