Electronics Forum | Thu Sep 15 13:55:31 EDT 2022 | jojoled
Hi all, I need help with problem Iam stuck with JUKI KE760L. -SERVO ALARM 1 and ALARM4 https://photos.app.goo.gl/CCDcNtbbEhJLBo47A Sometimes I do get error ON ALL 4 SERVO drivers (1-2seconds after starting the calibration routine (even before the Z
Electronics Forum | Tue Oct 20 23:14:01 EDT 2015 | kiwiguy12345
Hi, I have struck a problem with the X axis on my Juki 740. As soon as I "home" the machine the X driver displays the code "961" Does anyone have any ideas as to a solution for this problem? Thanks!
Electronics Forum | Mon Apr 19 16:07:32 EDT 2021 | sacd
Hello. When I am originating machine Juki KE20060RL Error On Initializing appear Z4-axis. The position error exceeded the limit. I am check and diagnosed that motor Z don't move at all. Attached axis monitor shows the current state of the axis . Coul
Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Thu Jun 10 22:13:01 EDT 2021 | roycet4
I would start by replacing the Z axis motor for head #4, you previously mentioned there was also a theta axis issue with head #4, you might be best served to replace both motors. These motors do go bad from time to time, We have 28 Juki machines wher
Electronics Forum | Sat Apr 28 21:13:11 EDT 2018 | stephenj37824
So lots of quotes and research later we have eliminated a few added a few to our choices lol. So it looks like we will be doing a decent volume now (due to our other board supplier letting us down as well). Roughly 4-5 million leds/connectors per mon
Electronics Forum | Sat Oct 21 17:41:05 EDT 2023 | basil_rv
Hi all! While operating the JUKI JX-350LED, error E600016 (Since the Z-axis is descending, it cannot operate) appeared. During initialization, this error appears, although all heads are raised. Rebooting and turning off the heads did not help. Wha
Electronics Forum | Thu Dec 26 13:21:28 EST 2024 | assuredtech
I'm troubleshooting a Juki FX-1R error, it came up after running a known good program, we powered the machine off, returned to work, powered the machine on and all Mitsubishi Servo amps go into an E7 error. None of the Axis move or initialize. I'm th
Electronics Forum | Mon Sep 05 11:51:30 EDT 2022 | jojoled
Can anybody help with Re-calibrating the Z-axis height in MS parameter , on JUKI KE760L? In MS parameter manual, there is information that these accessories are needed to recalibrate the Z-axis , can anybody tell where to get them, or ideally how to
Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
