Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Tue Oct 20 23:14:01 EDT 2015 | kiwiguy12345
Hi, I have struck a problem with the X axis on my Juki 740. As soon as I "home" the machine the X driver displays the code "961" Does anyone have any ideas as to a solution for this problem? Thanks!
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Tue Oct 01 18:44:24 EDT 2013 | richardconnell
Hi, I have limited capability on the Z axis. The axis will home to the mechanical switch limit and then drop to a point which I asssume to be the fiorst zero point below the mechanical switch limit. Then it gives the error. There is power to the mo
Electronics Forum | Mon May 02 15:59:46 EDT 2016 | donpito
Hi any of you guys has happened this error in GSM and machines as they could fix it " AXIS X2 Error Not Recognized During move home command"
Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
Electronics Forum | Fri Jan 28 15:22:07 EST 2011 | dougt
The PLC240-AK is an IC on the stepper board used to control all the stepper driven axis. I don't remember which axis are driven by stepper motors, possibly the table (x axis). Which axis acts wierd or doesn't move when you home the machine?
Electronics Forum | Sat Oct 24 10:41:40 EDT 2020 | phomann
Hi, This error popped up while running a panel through the machine. I put the machine into the Drift adjust mode and the y axis was drifting, but not smoothly like the X-Axis was. The Y-axis was drifting but not smoothly. It was more of a jerking mot
Electronics Forum | Tue Sep 23 14:23:19 EDT 2008 | jeffjarmato
Exact Error Message: Following error on Z axis Happens during Homing the machine. Right now as Z Up
