Electronics Forum | Tue Oct 25 22:54:55 EDT 2005 | KEN
sorry. re-read your post. The problem is the home sensor relative to the home pulse. You're catching the wrong home pulse. a 10mm offset sounds about right for a 360 degree error. You need 50% +/- 15 % to ensure you always zero to the same phys
Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Sun Feb 24 22:01:06 EST 2013 | mdang
Hi, I bought a used FUJI CP65 machine and the machine is lockup in home. I boot the machine up with Mecha-check mode and can home all the axes except FRQ axis. I look at the Clutch Origin and Messh-check sensor amp is it display 1,2 E (Error I think)
Electronics Forum | Sun Apr 12 08:49:12 EDT 2009 | mki
Hello, I bought used QUAD IVc MKII with transport in "as-is" condition, powered it up (without air and PCB on machine) and all axes (X, Y, Z AND T(heta)shows signs of life. Machine is performing HOME positioning self test. I am not familiar with QUA
Electronics Forum | Fri Sep 22 15:35:14 EDT 2006 | lheiss
Hello all, Finally ready to run my first 14 up array and the machine picks up the part moves to the placement location, them moves to home and drops the part. The Z axis never moves. I do get a "run error 1" at about the 4th placement (if it was a
Electronics Forum | Mon Aug 31 09:16:54 EDT 2020 | aurash
After reading the machine logs it seems that the problem is on the X-axis but the safety mechanism is disabling all the Servos and the Axis system (all axes) are in error state (that's why the error messages are showing on different axes) The JUKI m
Electronics Forum | Fri Sep 17 16:01:03 EDT 2021 | jamesatqkits
Hi Bukas, Do you have a CP45? I need some help: Ihave no board loaded, the machine is booted and homed. So to pick up a nozzle, I open the ANC window. Click on the nozzle I want, say 29 its a CN065 When I press pick, it asks, machine is not ho
Electronics Forum | Thu Mar 01 19:23:41 EST 2007 | SWAG
I could be wrong but I think the use for alternate feeder axis is a way of stopping the carriage so it does not always return to home every time an error condition exist. Saves on time and wear and tear on the machine. As for alternate carriage, I
Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
