Electronics Forum | Thu Jan 18 10:05:44 EST 2007 | SWAG
Make sure the program has been optimized to the current nozzle configuration.
Electronics Forum | Fri Jan 12 08:41:12 EST 2007 | geb
Hi, Our GSM1 pick and place machine has an Axis head 2 Z velocity error. None of the spindles of Head 2 work during placement and it brings up the error message. It will not proceed after that. I have tried lowering and raising the spindles in the
Electronics Forum | Mon Jan 15 11:12:08 EST 2007 | jaimebc
I've had experienced this issues here with our GSM's Flex heads. Try this: 1.- Clean your linear scales with alcohol and a lint free cloth. Both the X and Y. This one has fixed the majority of our errors when one of the heads just stops for no apare
Electronics Forum | Thu Jan 18 14:02:51 EST 2007 | geb
Thanks for your help everyone. For some reason it has started working again, without altering the program or settings!!?? So I don't actually know why it has done this. Thanks again, Grant
Electronics Forum | Sat Jan 13 19:34:16 EST 2007 | geb
(Its a flex head) I have made a trial program to determine at what point it stops. This is how it goes: I load the program, push the start button it will zero and pick components with head 1. As soon as it finishes placing head 1 parts it halts wher
Electronics Forum | Fri Jan 12 11:04:09 EST 2007 | mika
zero > in manual Control > bring the head close to the end of the machine so that you can reach the head => Diagnostic meny > engage the clutches and THIS IS VERY IMPORTANT: use Extreme Caution (you can flip off the X-Y circuit braker on the lower ba
Electronics Forum | Tue Jun 26 09:17:18 EDT 2007 | swag
You might try inspecting the drive belts in the head for missing teeth or other damage.
Electronics Forum | Tue Jun 26 08:47:09 EDT 2007 | geb
Hi we have a Universal GSM 1 flex head machine. It keeps on bringing up an "Axis Head 1 Z velocity over speed error during move absolute command". Pushing the e-stop button and then start again will allow it to continue making the panel. It happens r
Electronics Forum | Wed Jun 27 12:27:46 EDT 2007 | jaimebc
Same error here with our GSM1. Does your GSM have 2 heads? If so, this is how I fixed it. I didn't have a spare Z motor, so I swapped the Z motor for the front head with the rear head. Problem gone. Now since we don't use the rear head as much as we
Electronics Forum | Wed Jun 27 13:44:59 EDT 2007 | mika
Hi GEB, is this a similar problem that you had in the past? http://www.smtnet.com//forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=11260&#Message46667
