Electronics Forum | Tue Mar 02 17:41:04 EST 2021 | astarotf
The heads in the middle of production stop and this error appears. We already checked the readers, linear encoders and changed the UIMC cards and found no errors, apparently all these revised parts are working. Can anyone help us where else can we c
Electronics Forum | Fri Dec 10 02:49:06 EST 2010 | bagindia
we are facing vision error problem after running the machine for half an hour.Cause is x-axis motor % is changing & also motion is little harder compared with Y-axis
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Mon Mar 16 06:12:32 EDT 2015 | bobpan
The first thing to do is to change the z-rod. Sometimes a very old z-rod spring will weaken causing it to reject many parts. If it only rejects parts after a nozzle change....you may need to put some super lube grease on the O-rings on the bottom of
Electronics Forum | Tue Feb 07 20:43:59 EST 2017 | youngbuck
Does anyone know if there is a way around replacing the entire y axis tape measure scale for one scratch in it ,it can't read.Ive changed reader, y axis servo cards, taxis reader card.Any help would be appreciated.Thank you.
Electronics Forum | Wed Feb 06 06:14:01 EST 2019 | youngbuck
Try changing conversion board. 2 big ribbon cables plug in to it. p./n 00321189. or the 2 ribbon cables may need to be reseated. Thanks, Ryan
Electronics Forum | Thu Aug 18 02:39:21 EDT 2016 | epsltd
We have a Mirae 1030 and when the machine warms up the y-axis fails and we are unable to reset servos unless we leave machine powered down few hours. Now since we have changed servos after machine homes we jog the y-axis and it vibrates and very nois
Electronics Forum | Sat Jan 26 15:47:10 EST 2019 | dfl
I'm with an annoying problem with an IV-c. Almost all the time the Y-axis "stuck" when the machine is homing. The motor tries to move the axis but only make a sound. If I move the axis by hand it can complete the homing and then goes to the IDLE. So
Electronics Forum | Thu Jun 02 15:16:54 EDT 2016 | dilogic
I did try to null the axis - no improvement. I have AMC software and tried (almost) everything related to electronics (except for changing linear encoders, but this seems to be OK - when I move axis manually, position numbers change smoothly). It loo
Electronics Forum | Fri Feb 01 07:11:07 EST 2019 | bobpan
x and y are the same...just change switches. t and z are the same...just change switches. The voltages on the cards are different(x/y same--t/z same)....i do have a procedure somewhere that allows you to make an x/y card into a t/z card. good luck
.gif)
