Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Thu Nov 17 20:19:00 EST 2022 | emeto
I need to back it up with a something like IPC standard. It seems to me that people have used boards that aged after the 12months period, however there is no information supported by studies that can show results in quality and reliability of the boa
Electronics Forum | Thu Aug 25 11:15:16 EDT 2005 | dougs
do you mean the board support pins? generally anytime i've set these up i've just set the height as i've went, i put the pin under the board, with the board clamped, and move it up until it touches the board and set it there. you just need to make
Electronics Forum | Wed Nov 04 11:35:01 EST 2009 | dilogic
1. can you load cut tape onto the feeders, or only reels? You can, but you have to use cover tape extender (pretty cheap, though) >2. how about parts on trays (like Atmel AVRs in the QFP package)? You need tray feeder. But you can "make" your own
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
1 |