Electronics Forum | Tue Jul 16 01:12:31 EDT 2002 | ppcbs
We find that baking PCB assemblies at 90 degrees C in a Blue M forced air oven is safe for most all PCB's that we have encountered over the past 12 years. We remove any external plactic hardware that may be attached to the assembly and also like to
Electronics Forum | Fri Nov 07 09:34:31 EST 2003 | Rodion
Hello, I am writing a software that deals with chip placement on PCB and I would like to know if there is some standart way to describe what are the coordinates of the chips on the pcb, I know that Gerber file contains all the drill holes and tracks,
Electronics Forum | Mon Nov 17 08:01:44 EST 2003 | stefwitt
The format is X,Y Theta of the component center for all placement machines. Gerber data can be useless, unless you have the reference from pin 1 to the component center. Some machines offer a CAD convertion tool. I don't know any machine, which can
Electronics Forum | Thu Nov 27 02:52:33 EST 2003 | Giordano Trecca
I'm using a CIM software (http://www.aiscorp.com/products_npi_circuitcam.htm) to import gerber files and produce pick&place programs and paper/paperless documentation. It's very friendly, useful and fast, but not cheap. I don't know any other softwa
Electronics Forum | Thu Apr 13 07:30:09 EDT 2000 | Christopher Lampron
I agree with Nick. You should check with the manufacturer to determine what type of plating is used on the components and see if the manufacturer has any recomendations on materials that may help. If no exotic materials are used, the culprit is most
Electronics Forum | Tue May 26 06:56:40 EDT 2009 | xinxi
Hi! From your post, it seem like the wave did not really touch the component. You probably need to get the both wave height correct and that it hits the component.It is normal for solder to come through the PCB when using chip wave. The through-hole
Electronics Forum | Fri May 29 02:08:08 EDT 2009 | cobar
Check that you are getting an even spray pattern from the fluxer.Check that the chip wave nozzle is clean and if possible feed the PCB in to the wavesolder unit at 90 � or 180�.
Electronics Forum | Mon May 25 21:10:28 EDT 2009 | padawanlinuxero
Hello !! I have a problem with my wave solder oven, in one of the products we made has connectors on one side of the pcb and in the other one has SMT components the process is kinda tricky on the SMT components we use an adhesive and put to the refl
Electronics Forum | Fri Jun 20 10:27:19 EDT 2003 | Cristiano Dick Smiderle
Hi We are experiencing serious problem with ceramic capacitors. They are with low electrical resistence and the problem is intermittent. We found some of them with micro cracks but not all. What could be the causes for this problem? We are su
Electronics Forum | Thu Jun 13 20:55:46 EDT 2002 | russ
Having just gine through a similar problem myself (with much less equip.) Here are a few things to consider and/or look at Do you have the proper pad size? It should be the same size as the pad on the BGA. Is the board warping during your operati
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
