Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in
Electronics Forum | Mon Jan 23 03:17:10 EST 2006 | pavel_murtishev
Good morning, IR reflow is yesterday technology. IR heating principle has a lot of issues with heat transfer capability (shadow effect) and uneven PCB heating. To avoid this forced convection ovens were developed. Reflow oven for SMD soldering must
Electronics Forum | Mon Jan 23 14:09:14 EST 2006 | gipos
Hi Pavel, Thank you for your time.We wonder if anyone have experience with Panasonic - Panasert reflow oven model REF-A.It is used in Asia a lot. We have to chose among few models of reflow ovens : 1.Panasonic REF-A 2.Hollis(Electrovert) model Sur
Electronics Forum | Tue Jul 16 01:12:31 EDT 2002 | ppcbs
We find that baking PCB assemblies at 90 degrees C in a Blue M forced air oven is safe for most all PCB's that we have encountered over the past 12 years. We remove any external plactic hardware that may be attached to the assembly and also like to
Electronics Forum | Thu Nov 21 14:17:27 EST 2002 | MA/NY DDave
Hi I can't give you the answer for your question because I have too many questions and would have to know a lot more before I was comfortable giving any advice. I have done mass Baking of piles of PCB's as a needed evil when piles of boards were ex
Electronics Forum | Tue Nov 19 02:59:24 EST 2002 | yngwie
Hi Experts out there, pls help me with the following matters. How important is the bare PCB baking ? What is the temperature for baking @ what RH ? What would be the impact for the ENTEK finished board should the baking is really necessary ? For t
Electronics Forum | Tue Jul 16 00:53:39 EDT 2002 | kennyg
What is a typical time/temp baking cycle for an assembly prior to BGA rework? This bake is intended to prohibit PCB or nearby component damage as well as protect the component being removed for reball. A 24 hr bake at 125C would be great, but often
Electronics Forum | Wed Nov 20 16:53:18 EST 2002 | davef
Q1: How important is the bare PCB baking ? A1: Baking boards is a non-value added activity. Q2: What is the temperature for baking @ what RH ? A2: Search the fine SMTnet Arcives for bake recipes. Q3: What would be the impact for the ENTEK finishe
Electronics Forum | Fri Nov 22 08:57:56 EST 2002 | davef
Q1: What do you mean by "if the board is manufactured properly"? A2: If the epoxy is noy cured prooperly, for instance, the copper will not be well attached to the glass. So, peel strength will be lower. Q2: I don't believe that the peel off/or lif
Electronics Forum | Wed Nov 20 21:04:15 EST 2002 | yngwie
Hi Dave, What do you mean by "if the board is manufactured properly". If the board is not manufactured properly, humidity will have an impact on the peel strength? Is that what you mean. How does the Humidity impacted the peel strength ? Thru' which
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
