Electronics Forum | Mon Nov 04 07:27:33 EST 2019 | amitthepcbguy
There are multiple methods where you can perform top and bottom reflow soldering simultaneously. With this method, you might not worry about the type of flux there is. Each part is covered and baked as per the requirement, while making sure there are
Electronics Forum | Tue Jul 16 00:53:39 EDT 2002 | kennyg
What is a typical time/temp baking cycle for an assembly prior to BGA rework? This bake is intended to prohibit PCB or nearby component damage as well as protect the component being removed for reball. A 24 hr bake at 125C would be great, but often
Electronics Forum | Mon Oct 14 18:27:38 EDT 2002 | kennyg
In regards to baking an assembly prior to hot air (BGA) rework.... 1) Do people always bake, sometimes or never? Does this depend on whether MS sensitive components are near the rework site? If a BGA is to be removed and reballed, baking is a no-br
Electronics Forum | Tue Oct 15 10:12:44 EDT 2002 | davef
1) Do people always bake, sometimes or never? Does this depend on whether MS sensitive components are near the rework site? If a BGA is to be removed and reballed, baking is a no-brainer. Sometimes, based on the proximity of the MS components. >2)
Electronics Forum | Wed Mar 15 13:35:40 EDT 2017 | scotceltic
I have a double sided PCBA setup. I have MSL components on both assembly sides. When I run Assy Side one I am within the allotted hours remaining on the MSL component. I then wait 40 hours before running 2nd Assy side. By then the hours on the 1s
Electronics Forum | Thu Jan 31 13:19:28 EST 2002 | dason_c
What is the baking time/temperature standard for the PCBA before BGA rework?
Electronics Forum | Fri Apr 15 13:39:43 EDT 2022 | emeto
Bake a board. Measure weight. Measure board weight that haven't been baked.
Electronics Forum | Wed Dec 22 19:09:17 EST 2004 | rohman23
Very strange...I just logged into the internet to come post this very question for all the lurking experts. We have a 16 layer rigid-flex that we have never baked. Our board vendor is expressing concern that we do not perform a pre-bake before assy
Electronics Forum | Mon Mar 08 22:04:19 EST 2004 | pari
Dave i know abt the JEDEC033A specs..but this question is more of PCBA level. The baking temp and time at JEDEC is for MSD devices. I have tried to check IPC 7711 but the criteria does not mention the baking temp and time. Wandering is anyone is awar
Electronics Forum | Wed Mar 02 13:15:16 EST 2022 | chris007
I am currently working on a manufacturing flow where some PCBA are processed with reflow oven (after being baked before processing), then cleaned with bath, then passed into contaminometer, passed into AOI. The point is after all of this, if AOI dete
.gif)
winsouce.jpg)