Electronics Forum | Tue Sep 03 18:14:35 EDT 2002 | fmonette
I have never heard about a requirement for temperature ramp-up for baking components at 125C. In general the concern for delamination with moisture sensitive components starts above 200C (peak body temp). Most important is you should bake your com
Electronics Forum | Wed Aug 21 07:24:12 EDT 2002 | bayanbaru
What is the correct method to bake or cure the component?Standard baking practise by us is to place the units into oven at 125 �C for 8 hrs directly. But I was told that the correct baking practise is to cool down the Baking Oven to Room temp and onl
Electronics Forum | Tue Nov 19 02:59:24 EST 2002 | yngwie
Hi Experts out there, pls help me with the following matters. How important is the bare PCB baking ? What is the temperature for baking @ what RH ? What would be the impact for the ENTEK finished board should the baking is really necessary ? For t
Electronics Forum | Wed Nov 20 16:53:18 EST 2002 | davef
Q1: How important is the bare PCB baking ? A1: Baking boards is a non-value added activity. Q2: What is the temperature for baking @ what RH ? A2: Search the fine SMTnet Arcives for bake recipes. Q3: What would be the impact for the ENTEK finishe
Electronics Forum | Fri Nov 22 10:38:30 EST 2002 | slthomas
The follwing is from the Technet archives, per IPC's Jack Crawford. I dug it up during some investigation of a supplier's issues with humidity in an Asian plant: There is support for this in IPD-HDBK-001 w/Amendment 1 Handbook and Guide to Suppleme
Electronics Forum | Wed Jul 17 11:45:48 EDT 2002 | fmonette
The current IPC/JEDEC standard J-STD-033 for moisture-sensitive devices does not include a bake cycle at 90C (it includes cycles at 40C and 125C for non-assembled components in reels or trays). However, the upcoming revision, which should be release
Electronics Forum | Tue Jul 16 00:53:39 EDT 2002 | kennyg
What is a typical time/temp baking cycle for an assembly prior to BGA rework? This bake is intended to prohibit PCB or nearby component damage as well as protect the component being removed for reball. A 24 hr bake at 125C would be great, but often
Electronics Forum | Mon Aug 13 17:38:05 EDT 2001 | fmonette
Praveen, Once you find out the MS level of your components, you will need to track the exposure time from when the parts are initially removed from their dry bags, through test, programming, taping, and during subsequent dry storage and use of thes
Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in
Electronics Forum | Wed Oct 02 20:59:23 EDT 2002 | davef
We�ve been stewing on this and it just dawned on us the part that�s missing. Blow-holing is caused by BOTH of the following: * Moisture absorption by the resin that holds the board together. [Steve is addressing this with his various baking schemes
.png)
