Electronics Forum | Tue Jun 21 11:46:04 EDT 2005 | kenscj
Hi dave, Thanks for the comment. I have another issue. The board already pass Test and Burn-In processes, but after 2 months the BGA contact is found open (no contact on certain balls). How can that happen? Is it during build, the solder ball alrea
Electronics Forum | Tue Jun 06 11:57:12 EDT 2006 | Chunks
IPC 610 says acceptable Class 1 (Class 2, 3 indicator) if they are entrapped/encpsulated balls within 0.13mm of lands or pads. or exceed 0.13mm in diameter. Defect Class 1,2,3: Solder ball violates min electrical clearance. Solder balls not entrap
Electronics Forum | Tue Apr 01 18:42:18 EST 2003 | rdr
Well, here is what I have found so far. I have removed the top of the BGA and found that the ball had detached from the package. Three balls were removed with the two adjacent balls pulling the pads off the board and stayed attached to the BGA while
Electronics Forum | Thu Apr 03 09:08:50 EST 2003 | rdr
Thanks Scott,Iman, The problem has been isolated to detachment from package so I believe that there are no fabrication issues related to the Gold on the PCB. What is a Moyet analisys? where can I find more info? Dave, I am still waiting on Altera t
Electronics Forum | Thu Apr 03 11:17:17 EST 2003 | rdr
Well, first off now I'm just starting to believe that we are fracturing again. But here is some more input D1 ENIG? I would not have thought that they would be but as usual you are probably right. D2 Again I would have to agree about it should affe
Electronics Forum | Wed Sep 07 00:28:04 EDT 2011 | woodsmt
I have identified a Board design issue and having trouble convincing others of my findings. I have a BGA (Sn63 balls, +1500 IO, 0.6mm ball, 1mm pitch, with heat spreader plate)that has a high incidence of solder shorting on the corners. The board i
Electronics Forum | Wed Nov 29 00:43:45 EST 2006 | callckq
Dear all, Recently, we run 2 models with heat sink attachment on top of this BGA(on top of this BGA, there is flip chip attached at the center of the BGA). Hence, the center of the BGA is higher than corner/side. We used conventional way to attach
Electronics Forum | Thu Jun 19 21:39:31 EDT 2008 | mika
Hi, we used to have a RoHS package with uBGA 380 Solder ball's 0.8 mm pitch approx 15x15 mm, bump size is 0.4mm on a 0.33mm pad. Suddenly we need to use another vendor for various reasons. However, the new bump size is 0.45mm according to specs and t
Electronics Forum | Wed Jan 01 22:19:33 EST 2020 | sssamw
Solder ball attached on solder joint without violation minimum electrical clearance is acceptable. If your process parameter including stencil not changed, suggest you check if solder pasted being pushed out after IC placement, also check if solder j
Electronics Forum | Thu Jan 02 10:31:48 EST 2020 | slthomas
It is strange that you're having issues while using the same process parameters (including stencil) that worked successfully before. It doesn't guarantee that it's not one of those parameters changing in a manner that's not apparent, but it does sugg
