Electronics Forum | Mon Oct 21 08:46:15 EDT 2002 | davef
60% ||||36% of ball area|| >36% ||Class2|| Accept|| Reject ||||45% of ball diameter|| >45% ||||20.25% of ball area|| >20.25% ||Class3|| Accept|| Reject ||||30% of ball diameter|| >30% ||||09% of ball area|| >09% II. Missing Ball: This is prohi
Electronics Forum | Thu Aug 21 09:34:57 EDT 2003 | davef
Woa. The more paste that you put a a BGA ball, the more likely that you'll bridge between balls. Why do you need to compensate for the size variance in BGA balls? How does using a 8 thou thick stencil to compensate for ball size variance? Fine pi
Electronics Forum | Thu Apr 17 16:41:37 EDT 2003 | davef
60% ||||36% of ball area|| >36% ||Class2|| Accept|| Reject ||||45% of ball diameter|| >45% ||||20.25% of ball area|| >20.25% ||Class3|| Accept|| Reject ||||30% of ball diameter|| >30% ||||09% of ball area|| >09%
Electronics Forum | Tue Jul 15 15:46:05 EDT 2008 | slthomas
Can you describe your solder balls...mid-chip solder balls, "splatter" around pads, etc.?
Electronics Forum | Tue Apr 03 01:37:54 EDT 2001 | philipreyes
60% 36% 0f ball area >36% Class2 Accept Reject 45% of ball diameter >45% 20.25% of ball area >20.25% Class3 Accept
Electronics Forum | Fri Aug 18 09:07:22 EDT 2006 | russ
pretty much menaing Amol, that the balls are stuck to the board by flux and when you wash the flux the balls go away with it. If yopu are running no clean, then there will be no cleaning step and the balls will remain since the flux is basically unt
Electronics Forum | Mon Sep 22 04:59:10 EDT 2008 | fadzil66
I have concern about cleaning solder ball after misprinting paste on PCB, currently use vigon 200 with ultrasonic generate but only 70% solder ball able to remove, Any other method or equipment can help to clean solder ball.
Electronics Forum | Wed Apr 29 01:38:38 EDT 2009 | nibirta
already did this test. No solder balls. i have printed the pads without the component. No solder balls. Only with the component. The problem is, it splashing the around components. solder balls wew found on the body of a connector and on top of it. T
Electronics Forum | Tue Aug 25 13:30:35 EDT 2009 | rossi
It appears that the crack is between the paste and the ball. We physically pulled off the BGA by force and almost all the balls broke at the PCB. There was a thin layer of solder left on the pad. Maybe 1% of the balls stuck to the pad. I have attac
Electronics Forum | Fri Mar 25 04:28:54 EDT 2011 | grahamcooper22
Are the solder balls what we would call ' mid chip ' solder balls where a single or sometimes a few larger solder balls are positioned somewhere along the side of the chip or are they the solder paste powder particles spread around the pads ?
