Electronics Forum | Wed Nov 14 16:03:08 EST 2018 | cbeneat
Wondering if anyone will have an idea on what we are experiencing with our Panasonic. When the machine goes to change nozzles,it errors out saying "Nozzle exist error(Rack) occurred,(R side)" There is nothing in the nozzle bank, actually replaced ban
Electronics Forum | Wed Jan 31 08:26:36 EST 2007 | geb
I think it might be the feeder banks, that is causing the problem. I've tried picking a SOT-23 component using head 2 spindles 1-4 from a rear feeder bank and it is picking off centre. Doing exactly the same, but putting the feeder in a front bank it
Electronics Forum | Mon Oct 08 14:48:54 EDT 2018 | tey422
Need help on how to fix or temporary fix to bypass the "Rear feeder bank in lower position" error for the Juki 2080 machine. Even replace with different feeder bank won't fix. Any suggestions?
Electronics Forum | Wed Jan 31 19:16:46 EST 2007 | mika
BTW GEB; When you put the feeder in the front bank did you pick the comps with Head #2 and from the feeder bank just opposite from the rear non working feeder bank? Did you make your feeder banks fixed or is it already that? It just hits me, if you
Electronics Forum | Fri Mar 15 15:51:26 EDT 2013 | rway
Is this for something permanent? Where is the ground pad located (mid-bank, bank-end etc.)? What is the lead pitch? Are you looking on rerouting this pin some place else? Can you provide a picture of the pad in question?
Electronics Forum | Thu Oct 17 14:15:31 EDT 2019 | tey422
Try to check if there any foreign objects drop on the tool bank first. Even a tiny passive part could prevent the proper function of "open" and "close" of the tool bank. That's something to check too but always overlooked.
Electronics Forum | Fri Oct 18 16:26:54 EDT 2019 | mendezt6
Swap part method??? Are you meaning swap the tool banks? The tabs on the tool bank look good, but if it’s tweaked slightly that would be hard to tell. Sorry, I’m just an operator/programmer. The person that did all this stuff left suddenly.
Electronics Forum | Mon Oct 21 11:25:16 EDT 2019 | mendezt6
It sits flush in the bank and twist fine. The open and close are the 2 tabs on the tool bank right? When it’s closed the tool is twisted so it can’t pull up and open is the opposite?
Electronics Forum | Thu Feb 01 14:57:05 EST 2024 | cflames17
Have you tried reinstalling all the tools? This appears to be a problem with the tool bank being out of tolerance. Reinstall each tool in your tool bank one by one. Are the hydra tools ok?
Electronics Forum | Wed Mar 13 19:56:34 EDT 2013 | hegemon
It has been some time since I programmed a mirtec machine, but I think the technique would be to break the component into different banks of leads with unique locations. U25_Top, U25_Right, U25_LEft, etc... Use the centroid location to check presence
