Electronics Forum | Wed Aug 25 14:40:24 EDT 1999 | hammer
Has anyone used bar solder from a company called "Electrum Inc." What kind of results did you have?
Electronics Forum | Wed Aug 25 19:46:25 EDT 1999 | Dave F
| Has anyone used bar solder from a company called "Electrum Inc." | What kind of results did you have? | | Hammer: Try: Electrum Recovery Works 827 Martin St Rahway, NJ 07065 908-396-1616 800-622-1192 Canada 800-535-1192 Fax: 908-396-9390 John S
Electronics Forum | Thu Aug 26 08:17:07 EDT 1999 | Brian
| | Has anyone used bar solder from a company called "Electrum Inc." | | What kind of results did you have? | | | | | Hammer: Try: | | Electrum Recovery Works 827 Martin St Rahway, NJ 07065 908-396-1616 800-622-1192 Canada 800-535-1192 Fax: 908-3
Electronics Forum | Thu Aug 26 08:15:13 EDT 1999 | Brian
| | Has anyone used bar solder from a company called "Electrum Inc." | | What kind of results did you have? | | | | | Hammer: Try: | | Electrum Recovery Works 827 Martin St Rahway, NJ 07065 908-396-1616 800-622-1192 Canada 800-535-1192 Fax: 908-3
Electronics Forum | Wed Aug 23 14:59:32 EDT 2006 | bill
I�ve been lurking on the forum for a while so I will take a stab at this, mainly because there is no answer I take it that you have a variety of boards being produced at the same time and are in fixtures so the conveyors don�t need to be adjusted, a
Electronics Forum | Thu Jul 27 17:42:15 EDT 2000 | JD of Panasonic Create
Have you heard of them and where can I get information on their systems? Sincerely, J.D. jtalken@panasonicfa.com
Electronics Forum | Wed Jan 07 12:09:40 EST 2004 | Kris
Hi All, Does any body have any information on hot bar lead free soldering ? Need papers or experimental data ASAP Thanks
Electronics Forum | Thu Jul 31 13:42:08 EDT 2008 | comatose
I'm looking to fill a solder fountain with 50lb of SN100C. My usual source for paste and the like doesn't stock this alloy. We run double sided reflow, so we're not going to be needing hundreds of pounds for a wave machine at any point. Who is the
Electronics Forum | Wed Jan 06 14:34:20 EST 2010 | ppwlee
Hi, Has anyone have experience with manual soldering iron using automated wire feed? I am looking at poke yoke manual soldering 5 pins LCD and wondering if there are ways to control the volume of the solder applied to the board to minimize missing s
Electronics Forum | Thu Jan 14 15:36:23 EST 2010 | tds
JBC Tools has a wire solder feed solder iron. You can control how much is dispensed to the tip. I have sold several of these to customers soldering wires in to terminals. The hand piece is bigger than the typical solder iron but it beats the alter
.gif)
winsouce.jpg)