Electronics Forum | Thu Apr 16 08:07:05 EDT 1998 | Stan
Currently I am in the buisness of soldering bare die to the top surface of a copper heat sink. Is any one else have some exprience in this process that can help. We heat a copper slug through a contolled atmosphere, place a preform then a bare die.
Electronics Forum | Fri Apr 17 14:08:44 EDT 1998 | Earl Moon
| Currently I am in the buisness of soldering bare die to the top surface of a copper heat sink. Is any one else | have some exprience in this process that can help. We heat a copper slug through a contolled atmosphere, place a preform then a bare
Electronics Forum | Mon Oct 29 15:18:31 EST 2001 | Chris
I am attaching bare die using conductive epoxy. Thanks, Chris
Electronics Forum | Sat Nov 14 14:22:25 EST 2020 | davef
Steve wants to place bare die with the Zeva CT2000. Is anyone doing that?
Electronics Forum | Tue Jan 09 22:04:48 EST 2007 | Guest
Set Up Guy, I am not sure if the COB you are refering to means Circuit on Board . If yes, this process also include SMT . Package is a combination of some passive components and bare die. Passives are normally attached thru SMT using solder te
Electronics Forum | Wed Mar 29 18:17:16 EST 2000 | David
Does anybody out there have experience building electronics assemblies with DCA (Direct Chip Attach - bare die onto PCB) and wire bonding? - What Die Bonder/Dispensing Machines are recommended? - What brand conductive epoxy were used to attach die?
Electronics Forum | Sat Jun 15 22:39:05 EDT 2002 | edahi
well we can't paste the flip chip on its substrate because we are using flux...because this bare die yet...and the surface of the die flipped might be contaminated...also after chip attach and reflow the die is to be underfilled and if the die is pas
Electronics Forum | Tue Oct 09 14:10:24 EDT 2001 | cal
I am confused. You are using pressure sensitive tape. the pessure sensitive tape i have seen does not use cover tape.The pressure sensitive tape I am familiar with is called "Surftape" could you provide some more clarification?? Surftape is more co
Electronics Forum | Thu Oct 11 13:37:35 EDT 2001 | Stefan
The pressure sensitive tape is used as an alternative to heat sealed cover tape. It works usually quite well and is easily applied by the taping machine, but it can create some problems in the tape feeder. In the Surftape, Cal is referring to, the c
Electronics Forum | Wed Oct 01 15:45:35 EDT 2003 | Jalinous Esfandayri
Hi Everyone: Does anyone know what the right silicone for bonding the pressure sensor bare die on PCB is? How do I prevent the fracture and keep good adhesive? Any help would greatly be appreciated. Regards, Jalinous Esfandyari Intelligent