Electronics Forum | Wed Feb 28 14:25:33 EST 2007 | Bill
We have a board that uses a solder pad for one of the contacts of a button battery and had no problems when we were washing the boards. We are now using a no-clean flux and find that on a bunch of boards there is a coating of flux covering the pad s
Electronics Forum | Wed Feb 28 15:09:57 EST 2007 | Hussman
Some no-cleans will pool flux on the top of the solder joint which acts like an insulator. I normally do not paste "contact" pads. You can have your board house HASL them if you need the extra bump on the pad.
Electronics Forum | Fri Oct 17 09:31:21 EDT 2014 | rgduval
To be honest, I have never had success wave soldering or reflow soldering batteries, regardless of their intended use. If you're going to continue a manual operation to solder one pin, I'd suggest that you just solder the entire component in by ha
Electronics Forum | Fri Oct 17 15:23:28 EDT 2014 | davef
First, don't exceed the maximum temperature of the battery, say 85*C [I don't know your specifics] Second, don't short the terminals of the battery. Third, the best way to wave solder a battery is: * Insert an insulating tab between the battery an
Electronics Forum | Wed Aug 14 11:59:12 EDT 2002 | jseagle
I am trying to find a removable tab to place between a coin cell battery and the + contact of the battery holder. We want to have the battery installed in the holder and have the user remove a tab to enable the battery. Thanks James
Electronics Forum | Wed Apr 25 16:08:24 EDT 2001 | jmills
We build a product that requires a lithium battery. There is a Smt Battery clip soldered onto two gold pads on a FR4 PCB. The battery is forced by two little clips punched out to provided downward pressure in the battery holder, enabling the lithium
Electronics Forum | Wed Apr 25 16:09:45 EDT 2001 | jmills
We build a product that requires a lithium battery. There is a Smt Battery clip soldered onto two gold pads on a FR4 PCB. The battery is forced by two little clips punched out to provided downward pressure in the battery holder, enabling the lithium
Electronics Forum | Wed Apr 25 16:12:18 EDT 2001 | jmills
We build a product that requires a lithium battery. There is a Smt Battery clip soldered onto two gold pads on a FR4 PCB. The battery is forced by two little clips punched out to provided downward pressure in the battery holder, enabling the lithium
Electronics Forum | Tue Oct 27 03:22:43 EDT 2015 | pvogel
I'm looking for some SMD shims or something to solve this problem. We have a coin cell on a PCB and the side that contacts the PCB also has traces under the cell that don't connect to the cell. So I'm after some small dots of something suitable for
Electronics Forum | Tue Jun 20 17:23:04 EDT 2017 | snevermind
I have a stamped steel battery contact to pick that has a pick location 11mm deep in the tape. The factory machine settings only allow 6.6mm of "over-drive" depth past the top of the carrier tape. Based on that, I will need a custom nozzle that is
winsouce.jpg)
