Electronics Forum | Wed Apr 03 09:12:11 EDT 2024 | hta1979
You have to enter the setup utility.Power off the machine,connect AT keyboard to the rear port, power on,press f1, load the bios setup defaults, enter the hdd parameters,in the first menu (Standard CMOS setup) (Cylinder,Head,Sector,Wprecomp) save the
Electronics Forum | Wed Sep 25 13:25:13 EDT 2013 | nophsem
Hello bobpan: The machine is a QUAD 4C I turn on the machine and get the error: SRX AUTOBAUD Motor error #5 I removed the battery and then put it back in, the error remains. I removed the battery without put it back in...and turn on the machine,
Electronics Forum | Thu May 20 09:47:25 EDT 2010 | pforister
Is this a single head Quad IVc or a dual headed line? if it is a dual line you can swap the align cards in the front bay between the two heads and see if the symptom follows. The card on the far right is a transport card, shouldn't need to swap tha
Electronics Forum | Mon Sep 09 11:18:23 EDT 2013 | shirjer
We have a Vansco system on our 2005 Alpine Coach motor home. We have an intermittent outage problem with the 12V lighter socket. I can plug something in, like the tire sensor monitor, or the GPS, and after I remove it, the outlet no longer works, n
Electronics Forum | Thu Dec 30 04:59:19 EST 2010 | tpappano
Hello David, there are people here running these fine old machines. I have two, one I've been running for two years and another I've just acquired. It is not required to have a computer connected, but it will become handy for backing up and maintain
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Thu Oct 11 18:06:45 EDT 2007 | jmelson
Ohh, MY! Well, there is a whole block of info that is machine specific. There are 4 things on the main menu, the last one is the system calibrations. It has offsets between the primary reference (if you don't have vision, like mine) then the beam
Electronics Forum | Fri Aug 03 15:20:18 EDT 2001 | stmerkt
The press release attached below provides some insight into the direction Tyco is planning to head with the Automation Group. For Immediate Release Tyco Electronics Expands Automation Group; Offers Quad Systems Assembly Equipment Quad Systems
Electronics Forum | Wed Sep 01 03:48:26 EDT 1999 | Brian
| Is there any Legistration and(or) Regulation for Lead Free | | electronic product in Europe, U.S.A. and Japan? | | If you have any summarized data about that, Let me know. | | There is no legislation, as far as I know, in either the USA or Eur
Electronics Forum | Wed Sep 01 07:51:38 EDT 1999 | Earl Moon
| | Is there any Legistration and(or) Regulation for Lead Free | | | | electronic product in Europe, U.S.A. and Japan? | | | | If you have any summarized data about that, Let me know. | | | | | There is no legislation, as far as I know, in eithe
