Electronics Forum | Sat Dec 14 02:29:52 EST 2013 | padawanlinuxero
Hello I hope this helps For a component with axial leaded - vertical The clearance of the component body or weld bead above the land is 1.00mm (0.039in) Component body must be perpendicular to the board The overall height does not exceed maxim
Electronics Forum | Mon Aug 07 21:59:10 EDT 2006 | davef
It's inductor [choke] number 511. Probably used for EMI suppression on the monitor line. Look here: * http://www.antennex.com/shack/Dec99/beads.htm * http://lists.contesting.com/_topband/1998-11/msg00165.html *
Electronics Forum | Mon Mar 03 07:15:24 EST 2014 | JB
Thanks for the reply, how do people handle different packages then if you can't add new ones? If we had a 1206 sized inductor, then a 1206 sized ferrite bead and so on, they would all have to be grouped under the same generic heading? e.g. Chip-R321
Electronics Forum | Fri Nov 11 09:38:41 EST 2005 | Rob
Hi, There are 2 main steps to reducing EMI from a product. The first is to minimise it at source with smart design (keeping signal traces short, lots of decoupling etc). There should be design guides available from internet seach engines. Many ma
Electronics Forum | Thu Feb 21 03:25:58 EST 2008 | jlawson
I have seen smt chip varistors with Pd/Ag teminations that had poor wetting in terms of good fillet in LF (sac305) soldering. We found that the solder tended to be attracted to the plating on the part and off the actual pad (silver Immersion). This c
Electronics Forum | Wed Dec 15 10:47:57 EST 1999 | Christopher Lampron
I agree with Wolfgang. We are currently reducing appertures by approx. 10% even on the chip components. This still gives us an adequate fillet volume and very greatly reduces the probability of solder balling/beading. We generally refer to the manufa
Electronics Forum | Thu Jan 24 04:54:43 EST 2002 | wbu
Well Greg, I don�t know YOUR 0805 Pads but if you look at the recommended pattern for 0805 in IPC-SM-782 you might notice that the Z-dimension is somewhat about the size of your 1206 part length. With that and assuming that you ask if the results wi
Electronics Forum | Sun Mar 31 22:50:28 EST 2002 | ianchan
Nope, we do not have solder beads, like we said, what we have are near perfect solder fillets except for the portion where the component is "floating OFF" the pcb pads. We are now mucking through the IPC-A-610C for specifications dictation on "tilted
Electronics Forum | Tue Oct 15 17:54:08 EDT 2019 | davef
From J-STD-001: Components designed for pin-in-hole application and modified for butt connection attachment, or stiff-leaded dual-inline packages (e.g., alloy 42, brazed or tempered leads) may be modified for use on Class 1 and 2 products but shall n
Electronics Forum | Thu Jul 08 13:21:18 EDT 1999 | Bob Barr
Ron, We use 100 pin straddle mount connectors on some of our 1.6mm boards (up to eight per board.) They come to us from the vendor with a bead of solder on the somewhat 'J' shaped leads. Our process is as follows: Mount connector to board with hard
