Electronics Forum | Wed Jun 05 13:01:26 EDT 2002 | Hussman69
Sure do. Spent a couple months with that group last winter trying to get the Soft Beam to solder a small connector board. It really depends on what you are trying to solder. The Soft Beam couldn't handle my job because our board was too small. No
Electronics Forum | Wed May 07 18:08:10 EDT 2003 | kent_peterson
Steve, I onlyworked on the soft beam for a few months. With a good operator it ran good. The biggest problem i saw was the solder would break. The operators would try adjusting and end up moving the solder point. We had two machine back to back one r
Electronics Forum | Wed Mar 28 12:46:50 EDT 2007 | realchunks
Rob is right, you do need to dispense paste or pre-forms when using a laser. Although the Panasonic Soft Beam has a wire despenser. I've seen laser soldering and it does work on smaller stuff. Doesn't work well on connectors even after preheating.
Electronics Forum | Fri Mar 22 03:19:43 EDT 2019 | bukas
well, in video shown it looks like #1 motor drives head #1 upwards but does not detect home sensor being triggered. and then you get timeout error, head not being able to reach the position ( machine not registering it has reached position). since yo
Electronics Forum | Sat Mar 31 11:03:21 EDT 2007 | jmelson
I have a left to right conveyor, so the X offset is larger, but that is not major. You say "Make sure you are teaching with the unit that the machine defaults to or asks for." This is the beam sensor, and I have found no way to change this, either
| 1 |
