Electronics Forum | Wed Feb 05 11:31:40 EST 2003 | lloyd
The grease to use is DAPHNE EPONEX M No. 1 as you would expect it is made by an oriental company (IDEMITSU KOSAN). Sanyo recommend that this procedure should only be carried out by trained personnel, so it may be worth giving them a ring before you s
Electronics Forum | Fri Feb 14 17:25:17 EST 2003 | mikeo
Hello, As an Ex-Sanyo engineer I agree with the previous reply. Use EP1 sparingly. You may find that the nozzle sleeves are scored when you remove them. This is from lack of cleaning. You can only buy the sleeve and bearing from sanyo which is a was
Electronics Forum | Thu Dec 23 13:38:25 EST 2004 | clampron
Over The Hill, Sounds like you may have an incorrect height specified on a package causing the tool to slam into the board. The most likely cause is removing a magazine while the machine is running but I too have perfect operators who NEVER do that.
Electronics Forum | Thu Jul 19 17:10:43 EDT 2007 | jamyboy
You might want to check the Xwagon bearings. We had the same issue with the TP9-UFP we ordered all the possible parts Xmotors small large, encoder, transducer, couplings etc. over 10K worth of parts. The only thing we didnt order was the actual x-wag
Electronics Forum | Thu Jul 19 06:43:54 EDT 2007 | allgood
Hi Thanks for the input. Problem is only ever the A12 plastic tip (no damage ever seen on any other tool). I suspect we have not helped by skipping the retrim operation when we have changed a part so we'll do that but also I just discovered setti
Electronics Forum | Tue Jun 26 15:05:02 EDT 2012 | upguy
Thanks for responding Fred and Peter. We have had the same damage to the tip occur even though our TP9-UFP sits in an air conditioned room (74 F / 23 C). I spoke with Matt at MyData (who was very helpful). He said that the X-axis bearings, the X-a
Electronics Forum | Fri Jul 20 08:11:38 EDT 2007 | allgood
Well yesterday was uncharacteristically warm for a British summer! I always have the panel off the end of the machine at all times and certainly used to have a large desk fan blowing into it - for some reason I stopped. I had a run of strikes yeste
Electronics Forum | Wed Jun 27 03:43:24 EDT 2012 | allgood
Very interesting - esp that you have removed the temperature variable by being airconditioned. We defeinitely do not get strikes at 74 but do at 80 - but also we dont start the machine when its 80, that is the afternoon tempertaure on a rare hot day
Electronics Forum | Fri Jul 20 07:09:29 EDT 2007 | chrispy1963
Sr. Tech, youre absolutely correct that the X-Wagon (pancake) motor is the one which will do final positioning when moving to a programmed position. The X Axis motor in back of the machine is used for rapid traverse of the axis. I was thinking more
Electronics Forum | Tue Mar 05 15:50:46 EST 2019 | charliedci
Ours are all DLS-340 from Fancort. They don't appear on their website. Your description was accurate. 2 adjustable bearings with a spacer in the middle. Maybe a phone call to fancort might unearth something.
.gif)
