Electronics Forum | Wed Oct 19 15:38:03 EDT 2005 | chunks
Wow, all this BTU talk brings back bad BTU memories. Yes, the VIPs are good ovens, but the TRS series and Paragons were bad. TRS had air amplifiers - nuff said, while the Paragons had long spell of bad motor bearings because of design issues. Neve
Electronics Forum | Fri Jan 20 05:53:23 EST 2006 | dougs
i think it's more likely to be greasy/dirty shaft clutches, stand at the front of the machine and use the cam handle to turn the cam, while your doing this push up gently on the black top section of the shaft and try to turn the shaft, it shouldn't r
Electronics Forum | Wed Oct 17 17:51:13 EDT 2007 | jmelson
Yes, mostly. The computer just has a setting for which size frame it is in (66, 84 or whatever). The bearing slider is almost certainly the same, too, although the rails are a different length. As best as I can tell, my 1306/20 (which is NOT a III
Electronics Forum | Thu Mar 25 07:59:57 EDT 2010 | fredc
Hello Rodrigo, My expierence is with metal cutting machine tools not Fuji placement machines. That said there are a several of areas to look at. #1.Interference on your C axis travel, look for scrape marks or something dragging on the drum. #2. Tigh
Electronics Forum | Thu Nov 30 21:45:44 EST 2000 | Dave F
It's unlikely that anyone other than the biggest of whooses would think of 0.031" a fine pitch. I prefer 0.025" on tape with solder plated copper leads make in a shape that bears-up well after being driven over by a Mack truck, yet is compliant enou
Electronics Forum | Thu Apr 05 22:35:39 EDT 2001 | davef
This is similar to the question Steve asked earlier in the week about mixing OA and NC fluxes. I can't tell you. The answer would be provided by laboratory analysis. Top flight labs are: Trace, CSL, and Robisan. If you can't find contacts e-mail
Electronics Forum | Thu Jul 26 15:08:46 EDT 2001 | akruppa
We have done some work to reduce the amount of time that it takes to post to the Forum. We will continue to work on reducing the time it takes to post a message. This will be an ongoing project over the course of the next week. Please bear with us
Electronics Forum | Mon Jul 30 21:10:32 EDT 2001 | davef
The 5DX weighs 8000 pounds. Can your product bear the overhead? We use acoustic microscopy to find BGA opens. We have not had good luck finding opens with other inspection technology. Has Agilent told you that you can detect BGA opens? How is th
Electronics Forum | Tue Dec 14 14:49:57 EST 1999 | Larry Johnson
Okay, I have recently found tiny little ball bearings in side our CP4-2. Some have even been reported by operators to be found on top of the PCB while it is running. We have found about ten total so far, any ideas of where these would be comming fr
Electronics Forum | Tue Sep 29 08:17:30 EDT 1998 | Jim Zanolli
Teka Interconnection Systems may have a connector with their Solder Flux Bearing Lead technology -- by an economical pre-deposit of solder and flux on each connector lead, the connectors can be reflowed in convection with other SMD's without adding s
.gif)
