Electronics Forum | Wed Jul 11 14:25:16 EDT 2007 | cyber_wolf
Check bands Check friction Ceck that the bearing spindles that ride on the little rods arent bent. The custom centering jaws would be suspect Past that there is not a whole lota testing to do.
Electronics Forum | Tue Oct 09 10:18:56 EDT 2007 | lococost
We used to do this, but we dont any more. Never found something with the Mole. We have had 2 blowers come to a halt due to stuck bearings, but that was easely spotted without a check. (Temperature alarm and Huge whining noise)
Electronics Forum | Wed Oct 17 13:00:35 EDT 2007 | actech
so as long as the machine is a III series weather 66 or 84 you are thinking the electronics and possibly bearing may be the same?
Electronics Forum | Thu Nov 05 20:19:05 EST 2009 | martinwuest
I would switch to Teka PC104 solder bearing lead connectors. You can reflow them along with your SMT and eliminate hand soldering. I've had a lot of experience with them and they work great. http://www.tekais.com/pc104.asp Steve
Electronics Forum | Fri Jan 22 08:25:18 EST 2010 | davef
This socket supplier never expected you to do what you're doing to his/her part. Some materials bear-up under the thermal strain of reflow solder than others. Try different socket materials.
Electronics Forum | Fri May 07 10:20:11 EDT 2010 | cyber_wolf
There is no service manual for TM8's. I assume you adjusted the teddy bear face ? Hoffe, das hilft
Electronics Forum | Mon Jul 26 18:27:59 EDT 2010 | fredc
We make these also. Our nozzles are available as medium hard from heat treated bar (32 to 38RC) or very hard made from Bearing Quality 416 stainless. We can retip your Fuji nozzles also. www.nozzlesupply.com
Electronics Forum | Thu Sep 02 15:03:57 EDT 2010 | ccouture
a quick search on "life expectancy of linear bearings" will give you a clue on how any pick&place machine performance will decline with time. It's measured in distance travelled. So the more you use them, the more they wear out, the less precise the
Electronics Forum | Tue Sep 07 11:04:44 EDT 2010 | mikesewell
Looks like a hand solder process - getting paste down but not smearing it too bad while sliding the connector on is probably not worth the trouble. Teka makes solder bearing connectors which would allow you to install last and simply reflow with the
Electronics Forum | Thu May 12 16:23:00 EDT 2011 | vickt
Is this a consistent issue? Have you tried running in "step mode" to see if it's really a handling related issue (ie Clutch, bearings, etc)? Good Luck
winsouce.jpg)