Electronics Forum | Tue Jan 26 13:47:26 EST 2010 | swag
In addition to what Jeff wrote (I agree 100%) I would advise installing new theta drive belts on both heads. We had the same error at one time; if I remember right, I was told the new belts are better mat'l. It's likely your old ones are worn.
Electronics Forum | Wed Jun 27 02:24:28 EDT 2007 | jola
Check the drive belt first for missing tooth or bad tension. If thats ok you might need to change the clutches, they need to be changed every second year or soo. If they are worn out the wire driving the spindle might slip causing this problem. This
Electronics Forum | Thu Sep 13 06:26:01 EDT 2007 | chrispy1963
Yeah Sr., MyData is definately proud of their parts which shows in their pricing. We use outsourced parts where ever available. Belts for Ywagon tables, conveyor drive belts, ect.... We finally got a break on the tooling though! Finally found a way
Electronics Forum | Sat Apr 21 21:20:56 EDT 2007 | mika
Hi, Go for a very "slow down" turrent speed of 50 % and then see what is happening? It sounds that You could face a timing belt problem. I have seen this before. Another thing on this machine is whenever a slitghest misalignment between the the diffe
Electronics Forum | Thu Jul 21 14:05:19 EDT 2005 | cyber_wolf
Dave, I think I worded my post poorly. I am not sure if "tuning fork type" is the correct terminology. The instrument I am looking for usually has a hand held unit connected to a device that resembles a small tuning fork. As a matter of fact, I thi
Electronics Forum | Fri Feb 13 09:25:35 EST 2004 | jcdupree
Hi Patrick, I can easily troubleshoot ML, EL and SL 20 systems by phone or e-mail, but the MPC-29 is a bit more complex. The problem that you are describing was failry common, and there were a number of potential causes. First is to check if the dr
Electronics Forum | Wed Jan 17 21:19:08 EST 2007 | Jnet
I believe the drive of the conveyor whether rail or belt is the same so the sprocket choice in the software would effect belt or rail conveyor speed. I would make sure the number of teeth match the sprocket selection in the software.
Electronics Forum | Fri Jul 30 19:27:40 EDT 2010 | dman97
Hi All, Does anyone know how to repair a UP2000 that has the front squeegee lower than the rear? Can this be fixed by playing with the drive belts? The front squeegee is sitting lower than the rear and thus gives an uneven print stroke. The front s
Electronics Forum | Wed Feb 24 14:19:24 EST 2021 | marcelorotofrance
I am completely aware about the lack of kilos, other goodies and buggy software. I scratch my head when I read that they claim that they can do 0201 with belt drives and without linear encoders. In my personal opinion a KE family Juki would be perfec
Electronics Forum | Fri Mar 27 09:37:15 EDT 2009 | cyber_wolf
There are pem nuts on the back side of the teddy bear face. One of them probably fell off and either shorted your main board or it is lodged in the belt and pulley that drives the advancing wheels. Take the front part of the feeder off that has the t
