Electronics Forum | Mon Jul 31 20:34:58 EDT 2017 | zsoden
Hi all, it has been a bit of a delay but I've finally had a chance to do some further investigation on this. First off, we spend some time to clean the solder bath using Kester Solder Saver and scooped out a lot of crap. We then added about 5kg of
Electronics Forum | Fri Jun 23 12:30:24 EDT 2000 | Super K (Evil K)
To answer Gary's question: Gary, you will need a production board, thermal profiler, flux vendors product data sheet on the flux you intend to use, maybe your wave vendor service engineer or wave solder vendor contact (unless you know your wave) and
Electronics Forum | Fri Jun 23 12:32:20 EDT 2000 | Super K (Evil K)
To answer Gary's question: Gary, you will need a production board, thermal profiler, flux vendors product data sheet on the flux you intend to use, maybe your wave vendor service engineer or wave solder vendor contact (unless you know your wave) and
Electronics Forum | Mon Oct 12 03:09:06 EDT 2015 | akon63
Problem with cleaning these machines is once you > start it's easy to get carried away. ;) > > We > cleaned our SPA-400F a few months ago, had been > offline for a while as we were using our > SPA-250. > > It started as just a clean and to > r
Electronics Forum | Wed Sep 16 18:06:14 EDT 2015 | pmcg
Problem with cleaning these machines is once you start it's easy to get carried away. ;) We cleaned our SPA-400F a few months ago, had been offline for a while as we were using our SPA-250. It started as just a clean and to replace all the flux pip
Electronics Forum | Tue Jul 20 11:33:55 EDT 1999 | Ted Kress
| | I'm planning to introduce selective point-to-point soldering for pwb. This is due to various needs: PIHs assy on double IR, for example. I think the most suitable solution is a point-to-point soldering, 'cause we're still having small lot/many ty
Electronics Forum | Sun Oct 10 17:50:00 EDT 1999 | JohnW
| | We've recently encountered this problem where one of our .050" pitch BGA's were reflowing at the wave thus causing shorts... The board was profiled with probes stuck to a QFP solder joint, an 0603, and one of the BGA joints. There was an almost
Electronics Forum | Thu Jun 25 18:17:26 EDT 1998 | Earl Moon
| What is the industry standard for calibration compliance certification of SMT machines? and Flow Solder machines? | We are currently doing a Quality Audit on one of our manufacturing venders and this questions has been brought up. | Any help would
Electronics Forum | Mon Oct 11 11:13:32 EDT 1999 | Wirat S.
| | | We've recently encountered this problem where one of our .050" pitch BGA's were reflowing at the wave thus causing shorts... The board was profiled with probes stuck to a QFP solder joint, an 0603, and one of the BGA joints. There was an almo
Electronics Forum | Mon Jan 04 11:32:59 EST 1999 | Chrys
| Anyone have any experience with ECD's Waverider/MOLE profiling equipment? If so, were they positive experiences? | I use ECD's mole for profiling in the wave and a KIC for profiling in reflow. I like the KIC a whole lot better for a couple of re
winsouce.jpg)
