Electronics Forum | Mon Jun 25 13:21:15 EDT 2007 | Process Guy
I'm looking for an adjustable, bench top, gravity feed rack that will allow manual assemblers to pull parts to be placed by hand. I know I've seen these out there, but I can't find any information on them on line. Any help at all would be greatly app
Electronics Forum | Thu Jun 22 14:53:03 EDT 2006 | CL
Soboc, Mirtec does have support, service and spare parts in Oxford CT. Chris
Electronics Forum | Thu Oct 12 12:59:06 EDT 2000 | jackofalltrades
Does anyone know of a manufacturer of a Small Bench Top Convection Oven that could be used to reball BGAs? Right now we use Winslow Preforms and an Air-Vac DRS24 or our reflow ovens, but this ties them up too much and I'd like to keep reballing seper
Electronics Forum | Wed Dec 02 05:20:57 EST 1998 | Jim Mitchell
Quad still sells a low end convection/IR bench top oven for about $15,000. (ZCR 412B) It is limited to a 12" board but may work for your application. IR ovens have gone out of favor recently. There should be some older IR ovens for under $5,000 f
Electronics Forum | Tue Jan 11 14:21:22 EST 2011 | vmorina
Hello everyone, I've decided to go with a hot air bench top station for our prototype PCB. I would like to know other vendors besides Zephytronics and Weller's. Please recommend few other vendors that you think I should look into. Thank you in
Electronics Forum | Fri Dec 05 08:30:55 EST 2003 | pjc
If your operation is hi-mix low-volume, consider taking a look at some of the bench-top units out there. They are lower cost but can give similar performance as higher cost in-line systems. Some of the bench-tops cannot do solder fillet inspections t
Electronics Forum | Wed Dec 10 15:45:02 EST 2003 | Carl
If your operation is hi-mix low-volume, consider > taking a look at some of the bench-top units out > there. They are lower cost but can give similar > performance as higher cost in-line systems. Some > of the bench-tops cannot do solder fillet
Electronics Forum | Thu Sep 02 23:14:33 EDT 2004 | KEN
Not sure of what a bench top DI setup would look like. I use 3.5 Cubic foot tanks but have a special application that uses a 1 cubic foot tanks....even then its not a bench top setup. What is clean. No one can tell you. YOu can use IPC TM650 or t
Electronics Forum | Thu May 25 12:48:53 EDT 2006 | jbrower
Howdy, I have a Mirtec MV-TH2L bench top model and I like it. You could look at Yestech. They are in that range. The reason I like my Mirtec is that it programs up easily and does what we want it to do. So far in the last 4 months that we have ha
Electronics Forum | Fri Dec 14 07:03:54 EST 2018 | aantonielli
Good morning, I am a consultant of the Court of Milan and I have to estimate the value of about 60 machinary Insite B Bench Top, manufactured in 2013. I wonder if these machines are still desirable on the market (eventually making some Investments/ad