Electronics Forum | Thu May 04 10:29:40 EDT 2006 | Chunks
"Bending nozzles" "Changing dwell times" "Navels" (!!!!!!!!!??????????) And probably not taking responsibility when the poop hits the fan cause "you're just an operator". Not knowing your boards, but estimating your time scenario, I'd say you're sol
Electronics Forum | Sun Mar 15 23:48:59 EST 1998 | Phill Hunter
| | | Has anyone had any success in repairing Fuji CP nozzles in house? Removing bent press fitted nozzle and replacing. Any input would be appreciated, please no solicitation from repair shops | | Rob, | | What model of CP? | Mr. Kooki | CP4 and 6
Electronics Forum | Fri Jul 10 08:50:04 EDT 2015 | jax
Is the feeder working properly... presenting the label at the same location each time it indexes? If yes, I would look at changing nozzles on the machine. sometimes a rigid tipped nozzle cannot maintain suction on thin items like labels that can ben
Electronics Forum | Wed May 03 21:20:23 EDT 2006 | mumtaz
I too use to run Ersa machines. The new engineer has gotten me kicked off them because I know more than he do. we operators are on the machines all day, so we know more than than the engineers. They may be good on the computers, but we now the mac
Electronics Forum | Thu Mar 24 19:17:43 EST 2005 | EA
Hi, We are running the automotive product and question was throw to us how do we ensure that our solder joint are good enough after reflow.....and during the sealant process, there's a bit of bend on the nozzle and it toughes the component and custo
Electronics Forum | Mon Jul 28 19:03:53 EDT 2003 | Ryan Liao
Hi mantis, Thank you for your helps. I had checked the CP7 error code index application. It also gives me the same answer. It tell me " the part pickup status is bad" and I have to "Make sure that the nozzle is not bent and that the part is being pro
Electronics Forum | Fri Sep 15 15:55:27 EDT 2006 | jdengler
Bert, Hopefully the MCS still has PD's from Fuji or the previous user. The Transverse rate IP set in them should be a good guide for any new PD's you may need to make. This speed is usually set as high as possible and still get accurate placements
Electronics Forum | Fri Jul 07 13:32:30 EDT 2006 | David
Hello We have notorious problem with TopazXi FNC head and bending head number one shaft. So far service can't find the root of problem. Looks like problem is related with nozzle station and head hit the station. All sensor head down, nozzle are co
Electronics Forum | Thu Oct 20 16:42:53 EDT 2005 | PWH
Does anyone know if it is possible to run 0402/0603/0805/1206's on a Samsung CP30V vision system? I'm attempting to get some life out of this machine but greatly dislike the chucking nozzles. My hope is to run rect. packages accross vision using M1
Electronics Forum | Fri Mar 10 15:47:35 EST 2000 | Casey Scheu
Russ, As I stated earlier 100% satisfaction guaranteed. I'd like to address a couple of your problems. 1. Lack of TC control. I don't really understand this issue. The system is a closed loop system w/ the TC located directly in the nozzle block.
