Electronics Forum | Thu Feb 06 14:06:09 EST 2014 | rgduval
If you get a response to this, I might have a need to look into something similar. Though, I don't need adhesive..I need something more like kapton or masking dots. I am working on a new job that requires conformal coating, and LEDs that need to be
Electronics Forum | Mon Jun 29 16:03:24 EDT 2020 | spoiltforchoice
I certainly can on the Paraquda and I suspect the basic algorithms are the same. Slimmer annular rings such as you might get on a plated via hole don't always image quite as well but if for some reason it doesn't pick it up you should be able to inte
Electronics Forum | Tue Aug 01 13:31:48 EDT 2017 | tey422
There is one thing to be checked too. That is to make sure the nozzle not going too deep when lower to pick up the part. I found a lot of picking errors issues are due to nozzle going down too deep into the pocket. If it does, it pushes the component
Electronics Forum | Mon Aug 02 06:15:01 EDT 2004 | ts
Hi For throughput seimens is the best and footprint is smallest
Electronics Forum | Mon May 08 09:08:17 EDT 2006 | Rob
http://www.sinclairc5.com/ Sorry, but the old ones are the best.
Electronics Forum | Wed Aug 15 14:27:17 EDT 2007 | smtrepair
Not to mention if the part was loaded in the correct position or if a inventory picked a wrong part.
Electronics Forum | Tue Aug 12 14:49:26 EDT 2008 | awegener
I'm attempting to pick and place a small rivet onto our PCB. The rivet should be attached via reflow solder. The rivet will be used to create a sandwich, holding together a frame and additional circuit board in a package. This part is intended onl
Electronics Forum | Tue Nov 06 10:28:58 EST 2018 | davef
Media Links IPC Global Insight This weekly electronic newsletter includes IPC news and multimedia information on manufacturing and management best practices and solutions, new technologies, standards, government relations and environment, health and
Electronics Forum | Thu Aug 31 05:20:08 EDT 2000 | dougie
Thanks for your help guys. We've V-scored boards in the past and it led to difficulties, as mentioned with the depth of groove etc... Our PCB's vary in shape and size drastically, and I mean drastically. So it looks as if a little more though on wh
Electronics Forum | Fri Jul 11 03:35:44 EDT 2003 | emeto
Hi there is one thing. I had the same problem before and after examine it I found the problem is in the pads. The pads on the board were bigger then usual and the distance between them also was a little bit longer.Theese two are the best precondition