Electronics Forum | Thu Sep 05 03:23:14 EDT 2002 | manic
Hi, I encountered a problem with pbga. One edge either warp downwards or upwards creating bridging or open. This pbga have fr4 at the bottom (compound molding at the top). The fr4 is bigger than the top compound by 3mm at each edge. Pls help. Than
Electronics Forum | Tue Sep 10 08:22:36 EDT 2002 | davef
I doubt that the interposer is FR4, it's more likely to be BT. Warp during reflow is a function of material a reflow recipe. Your ramp is too fast and is causing the interposer to bend like a potato chip.
Electronics Forum | Tue Sep 07 22:15:26 EDT 1999 | NAZEEH CHAUDRY
| | | I have a zevatech 570 and 560 my boss want to place bga.s with these machines, Ive told him he needs to ugrade to newer machines. Zevatech say "no problem our machine are number 1". | | | these machines dont even offer bga selections. These mac
Electronics Forum | Tue Mar 02 10:19:41 EST 2004 | loz
Hi all, we have recently seen a design that consists off a QFP100, pitch at 25". Also in the centre of this footprint is a FBGA165 footprint, pad size .4mm @ 1mm pitch. We have been informed that we will fit the QFP. I want to remove the BGA pads fr
Electronics Forum | Thu Sep 12 01:49:28 EDT 2002 | ck
Hi all, Any stencil opening recommendation for 20mils pitch mirco BGA. Currently, using 12mils round opening, 5 mils thickness. Seen to have weak joints as it crack after Ict testing. thks
Electronics Forum | Mon Oct 13 19:04:47 EDT 2003 | davef
Aperture size should vary with the component [pitch]. That size should be the same a the pad size. So, generally pinching is not required. Indium discusses BGA apertures on their site [ http://www.indium.com ]
Electronics Forum | Mon Oct 13 13:49:29 EDT 2003 | mrmaint
Does anyone know of a standard stencil thickness for BGA'S. We currently use 4 to 5 mil stencils depending on component mix. Is an aperature reduction required for BGA'S. If so what percentage. Any help would be greatly appreciated. Thanks MRMAINT
Electronics Forum | Tue Mar 05 22:35:49 EST 2002 | Nell
Hi Pete and Dave, I already check with Practical component, Tessera and TopLine Dummy component they said they only have up to 0.5mm pitch CSP. Anyway, thanks for your input... Do both of you know in the market right now is there any 0.4mm pitch C
Electronics Forum | Mon Dec 16 10:23:42 EST 2002 | Grant Petty
Hi, I have checked the archives, but need some advise. We have a 256 pin 1 mm pitch BGA part of our boards, and we have having problems with paste release our of the holes for the BGA. We just cannot seem to get it right, and we have to keep the st
Electronics Forum | Wed Dec 18 15:38:59 EST 2002 | swagner
I have had a similar problem in the past, since I have never worked with a semiautomatic printer there could be a few things I recommend that will not work for you. 1. Make absolutly sure that you have proper support under all of the BGA's. 2. Print
