Electronics Forum | Thu Dec 05 17:40:24 EST 2002 | davef
While unfamiliar with some of the terms you use, could this be what you seek? http://www.pcbstandards.com/downloads/Metric%20Environment/General%20Documentation/PCB%20Design/PCB%20Design%20Routing/Metric%20BGA%20Routing.pdf Stepping backwards just
Electronics Forum | Fri Aug 22 00:20:29 EDT 2008 | rameshr
Hai, In our process we are using the micro bga of size 13X13mm of pitch 0.45mm,after soldering process the bga found collapsed, we absorbed that the PCB land pattern of the BGA was not in array, uneven distribution of pads (area) & most of the pads
Electronics Forum | Wed Nov 23 19:50:23 EST 2016 | gmscribe
Hi guys, I'm working on a design involving a 223-pin BGA with 0.5mm pitch (ball size 0.3mm) with a 16-bit DDR3 controller involved. Currently routing a track between two balls is resulting in a track width of 0.1mm and a spacing of 0.077mm. Now the
Electronics Forum | Mon Sep 08 01:45:35 EDT 2008 | rameshr
1.The Temperature on the pad is 247.C & also it is an lead free profile, the same profile we have used till last lot but we had obsereved this problem earlier to this current batch. 2. Both in Type3 & Type 4 paste we are using because of we are using
Electronics Forum | Thu Nov 14 10:52:56 EST 2019 | jandon
Maybe something like this could work?
Electronics Forum | Tue Nov 12 00:49:37 EST 2019 | myke03o
I am optimizing a stencil opening for BGA with 0.4mm pitch and pad diameter of 0.2mm. Can anyone advice of stencil thickness and stencil opening I can use in order to have a good paste release. Thanks for all your answers.
Electronics Forum | Mon Oct 08 23:17:48 EDT 2001 | Brad Arnold
We are trying to produce a PC Card bus assembly with a 672 pin BGA on one side. These pcb's are .015 thick. I believe the ball pitch is .5mm. The pcb's are plated with white tin. The pcb's are in a 1 X 3 array. We had 2 plates with appropriate cutout
Electronics Forum | Tue Oct 09 20:27:13 EDT 2001 | davef
That�s a 672 BALL BGA, bud!!! It�s a BIG Mutha!!! [I know. I know. For some reason suppliers call balls "pins".] Let�s focus on: * Clarifying the units on your PCB and aluminum plate thickness measurements. * Describing your use of the aluminum pl
Electronics Forum | Thu Oct 11 17:44:30 EDT 2001 | aaelect
OK, OK. 672 ball BGA. The pcbs are PC Card bus size and are .015 thick. There are 3 on a panel with about 1/2" between and rails. The aluminum plates are about 3" by 7". There are 3 cutouts which allow for the parts from either side to protrude du
Electronics Forum | Thu Nov 14 18:25:07 EST 2019 | myke03o
Hi Jandon, Thanks, I will try it on my DOE.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830