Electronics Forum | Thu Nov 10 00:38:54 EST 2011 | tpappano
Hi Jeff, no problem, I'll just pop them out and make copies. I'm betting the upgrade will take care of these silly problems. The machine with the "newer" firmware just goes and goes without any issues other than replacing that R-axis servo a while
Electronics Forum | Wed Jul 13 16:51:28 EDT 2005 | KT
we do it all the time. We havent had any problems with the BGA's. But, you dont want BGA right beneath another BGA.
Electronics Forum | Wed Jan 20 20:01:27 EST 1999 | Tony Arteaga
| | Does anyone have information pertaining to re-balling BGA components using balls that are preformed onto disolable paper waffers (mini BGA reballing kit)? The paper containing the specific BGA device/pattern would be placed onto the BGA then pro
Electronics Forum | Fri Jan 15 14:49:32 EST 1999 | Dave F
| Does anyone have information pertaining to re-balling BGA components using balls that are preformed onto disolable paper waffers (mini BGA reballing kit)? The paper containing the specific BGA device/pattern would be placed onto the BGA then proce
Electronics Forum | Wed Jun 30 18:36:21 EDT 1999 | Mark
| Does anyone have information pertaining to re-balling BGA components using balls that are preformed onto disolable paper waffers (mini BGA reballing kit)? The paper containing the specific BGA device/pattern would be placed onto the BGA then proce
Electronics Forum | Fri Oct 28 02:18:03 EDT 2022 | kamedatec
I bought a YV100XG machine with AutoTC (Automatic Tray Feeder), Everything is working except AutoTC, when I active this function, pops up the error that the Servo Motor LZ1 was not found. I changed the control card of the servo motor, checked the wir
Electronics Forum | Wed Feb 24 22:11:22 EST 1999 | E. Coli
Looking for a few good seminars here on the east coast (NY, NJ, PA, etc) on the topic of BGA's, BGA Repair and Rework, etc. Any suggestions ?? Thanks.
Electronics Forum | Sun Aug 01 11:39:41 EDT 2004 | Andrew
I am seeing high rate of open joint at NexLev connector and also BGA warpage issue with 52 mm Hyper BGA.anyone has the same experience?
Electronics Forum | Wed May 24 15:59:34 EDT 2006 | JohnM
I have a product with mixed in Pb free and Pb BGAs. I decide to use SnPb paste with Pb free reflow profile to make it work for both types of BGA. Do I have a reliability solder joint issue by using this method? How is your opinion on this case? Can
Electronics Forum | Wed Jul 22 12:34:43 EDT 1998 | Frank Silva
| | We need BGA rework station and x-ray inspector recently in urget case, Do you have any information to rework FPGA package and inspect them during processing. | Thx for any information | Best Regards, | Stoney Tsai Stoney, Check out Nicolet Imagi