Electronics Forum | Fri Jun 10 13:04:04 EDT 2011 | spitkis2
Any suggestions as to what can cause a PBGA's corner to warp down during installation process on a rework system? A couple solder balls bridge at the corner. It appears at the pin 1 corner where the metal indicator of a BGA is exposed. I am wonder
Electronics Forum | Thu Jul 23 11:39:16 EDT 1998 | Russ Miculich
Are you using a HASL board or an organic protection on the pads? This will help determine as to whether paste is necessary or just a very active/tacky flux should be used. Tight process control will also help in the reflow oven. Many users don't wan
Electronics Forum | Fri Mar 21 09:08:53 EST 2003 | mantis
Hi all, I have a strange problem,while building a large 15x15inch 3.5mm thick Pcb.During topside reflow i am experiencing some misaligned parts and even bridging on a bga that are sitting very close to a D size tantalum cap.The strange thing is that
Electronics Forum | Thu Jun 08 01:46:00 EDT 2023 | camilleyang3
To prevent BGA (Ball Grid Array) issues related to SMT (Surface Mount Technology) solder resist when fabricating a PCBA (Printed Circuit Board Assembly), you can follow these guidelines: Design considerations: Ensure proper spacing between BGA pads
Electronics Forum | Thu Jun 13 20:55:46 EDT 2002 | russ
Having just gine through a similar problem myself (with much less equip.) Here are a few things to consider and/or look at Do you have the proper pad size? It should be the same size as the pad on the BGA. Is the board warping during your operati
Electronics Forum | Mon Oct 11 11:13:32 EDT 1999 | Wirat S.
| | | We've recently encountered this problem where one of our .050" pitch BGA's were reflowing at the wave thus causing shorts... The board was profiled with probes stuck to a QFP solder joint, an 0603, and one of the BGA joints. There was an almo
Electronics Forum | Wed Jun 01 02:02:07 EDT 2005 | jackt
Has anyone experience with stacked BGA rework? If yes, appreciate you can share it with me. I 'm facing solder bridge after rework. thks...Jack.
Electronics Forum | Fri Nov 25 09:31:56 EST 2005 | davef
pyramus, First, search the fine SMTnet Archives for previous discussions on BGA shorts. Second, we're still not clear on the issue. * Is the problem with a BGA? If so, please describe the BGA, including any heat spreader * Is the problem with a uB
Electronics Forum | Fri Oct 09 10:57:25 EDT 2009 | clampron
Omid, I have used the DRS24 for many years and have had similar problems with what you are talking about. I do not have any documents but I will tell you what I have seen. It sounds like an inconsistant collpse of the BGA. If one side of the BGA col
Electronics Forum | Thu Jul 29 00:42:32 EDT 2004 | C.W
hello, BGA was a little excessively reflowed with dwell time(above 183C - solder paste = 63/37) over 2 min, peak temp is 218C. I inspected the BGA under X-ray and there is a little voids but within the acceptable range, i then used the Ersascope to c