Electronics Forum | Thu Dec 07 14:17:03 EST 2006 | russ
I would bet that it is a SMT adhesive used to ensure that the BGA does not move during a secoindary reflow prcess. this glue is easily removed with a soldering iron. Russ
Electronics Forum | Thu Dec 07 12:18:28 EST 2006 | realchunks
It may be for a double sided reflow process. Yes, some people do put the BGA on first. I know this first hand.
Electronics Forum | Wed Dec 06 21:59:37 EST 2006 | SMTrework
Hello, we rework BGA packages that come back from the field. I've seen on occasion a black and or red "epoxy" substance from the manufacturer on the corner of some board's BGA chips that I imagine are applied to increase corner bond of the chip to th
Electronics Forum | Wed Dec 06 22:35:05 EST 2006 | davef
Questions are: * When you say, "corner of some board's BGA chips", is it on the top of the package or between the board and the bottom of the package? * If between the board and the bottom of the package, does it span the distance between the board a
Electronics Forum | Thu Dec 07 03:21:54 EST 2006 | Guest
Materials you see are corner bond adhesive, main purpose of this is mechanical shock absorber , it promotes additional adhession to lessen stress to solder joints incase device subjected to mechanical stress like dropping.By function, corner bond
Electronics Forum | Wed Dec 06 22:46:39 EST 2006 | SMTrework
Hi Dave, This is manufacturer applied epoxy / adhesive to minimize package "lifing" from chassis flexing and thius board flexing. I have seen the complete array area covered with this black or red epoxy in some cases (i.e. the underfill that I've
Electronics Forum | Thu Dec 07 19:54:55 EST 2006 | davef
We agree with "guest" above. This a "chip bonder" type material used to improve the reliability of array type devices. "A relative comparison of the N50 values is given below: No underfill = 1.0X (baseline) Corner bond = 1.3X Non reworkable underfi
Electronics Forum | Mon Feb 22 12:04:15 EST 1999 | Dave F
| Please could you suggest a recommended aperture sizes for | printing of smd adhesives. Any recommendations on stencil thickness as well as stencil finish will be appreciated. | Mark: About the only rule of printing adhesives is: Keep it off the
Electronics Forum | Sun May 21 09:38:25 EDT 2006 | davef
Epoxy Removal and IC Delidding [Hardware Hacking: Have Fun While Voiding Your Warranty, Chapter 14] Encapsulation of critical components using epoxy or other adhesives is commonly done to prevent tampering and device access (the microprocessor shown
Electronics Forum | Thu Oct 13 10:44:18 EDT 2011 | spitkis2
Have you considered adding adhesive / epoxy at the corners of the BGA to secure it in place?
1 |