Electronics Forum | Thu Feb 07 08:08:20 EST 2008 | scottp
We also use machinists dye. I like to pull a vacuum on the board after wicking the dye under the BGA. It seems to help fill fine cracks. I'll stick it in a warm oven if I'm in a hurry for the dye to dry. Then just bend the board to pop off the BGA.
Electronics Forum | Wed Feb 06 09:40:05 EST 2008 | phouwen
We are experiencing some difficulty in BGA assembly and would like to do some periodic on site dye and pry after different assembly processes. Does anyone do this now? Is it actually feasible? Does anyone have recomendations on equipment/dye suppl
Electronics Forum | Fri Mar 30 11:05:44 EDT 2007 | realchunks
Hi Chris, A lot of it has to do with your product, t-shooting devices and techs ability. There are ways to determine BGA are at fault. X-Ray is a good way to check for shorts. Insufficients are harder to find. Some people use a dye. They squirt
Electronics Forum | Fri Apr 01 23:32:39 EST 2005 | ccgooi
Hi, I would like to understand more about dye and pry process for BGA assembly. Can anyone provide me more information about reference about this topic.Thanks.
Electronics Forum | Fri Jun 27 22:33:16 EDT 2003 | Ben
HI, I'm doing a dye penetrant and peel test of non-function BGA solder joints to locate the fracture surface. After applying dye, I found the dye ink just accumulate at the solder mask edge and spread everywhere after I peeled off the package. THis i
Electronics Forum | Wed Mar 12 07:33:40 EDT 2008 | callckq
Hi All, One PCBA failed test after went through the Shock Test(Vibration) and suspected to be BGA solder ball crack. We performed dye and pry and found PCB's pad lifted with red mark ink penetrate pad underneath, what does this mean? Can I say the
Electronics Forum | Thu Oct 24 14:10:53 EDT 2002 | Terry Burnette
I've been informed that I can't post the Dye Penetrant paper on the SMTNET library till Advanced Packaging releases the paper in their Dec. issue. You should be able to pull a copy in the next couple of weeks from their site, http://ap.pennnet.com/ho
Electronics Forum | Mon Apr 06 09:04:31 EDT 2015 | jesseoliveira
Hi all! I work in FA Lab on Brazil. Recently we had a problem with a dye pry analysis of BGA component due to breakage of WLP package (wafer level packaging). In this case, WLP thickness is about 0.28mm and was damaged during pullout process. Our
Electronics Forum | Tue Apr 01 09:58:52 EST 2003 | davef
You're entirely correct. The gold is most likely gone away. [Don't forget you can check if the surface is still solderable with a hand soldering iron.] We're not sure it it will give you the results you seek, but consider using a dye penetrant fai
Electronics Forum | Wed Sep 12 18:11:03 EDT 2001 | davef
First, what on the area array package are you analyzing � * Package cracking? * Cracked solder balls? * Er, what? Second, most failure analysis discussions consider dye penetration to be a non-destructive test, but then again most failure analysis
winsouce.jpg)